COVER 3P2438 - Caterpillar

Connections For AC Power Source
(1) Connect blue wire to No. 1 Connector.(2) Connect black wire to No. 7 Connector.(3) Connect red wire to No. 8 Connector.(4) Connect wires of one resistor to Connectors 7 and 9.(5) Connect wires of the other resistor to Connectors 8 and 10.(6) Connect the No. 1 wire from the motor to Connector No. 1.(7) Connect the No. 2 wire from the motor to Connector No. 2. (8) Put circuit board (1) in position in grooves (A) of the housing. Be sure the circuit board goes in the groove at the bottom.(9) Install the new decal for the wiring diagram to the bottom side of the governor cover. Install the governor cover and tighten the screws to 25 lb. in (2.8 N m).(10) Correctly connect the power source to the governor and turn on the fuel supply. To check the performance of the synchronizing motor before the engine is started, move the motor switch to RAISE. The synchronizer knob on the front of the governor must move to RAISE position. Move the motor switch to LOWER and the knob must move to LOWER position. If the motor does not operate correctly, find and correct the problem.