COVER AS 4646025 - Caterpillar

Which Generate This Code:This diagnostic code is associated with the calibration of the lift valve and the tilt valve. Insufficient data has been collected during the valve calibration. The blade is moving too fast during the calibration procedure. The calibration limits are too low.System Response:When this diagnostic code is active the "Data Error" is shown on the "Display".Test Step 1. CHECK THE LASER TRANSMITTER
Verify that the setup of the laser transmitter is stable.Refer to Operation and Maintenance Manual, "Laser Transmitter Setup Information (Dual Mast System)".Note: Ensure that there are not any obstacles between the laser transmitter and the machine. Ensure that the laser transmitter is between 50 - 100 feet away from the machine.Expected Result:The setup of the laser transmitter is stable.Results:
YES - The setup of the laser transmitter is stable.Repair: Repeat the valve calibration. Be sure to reset the upper and lower limits for the calibration procedure to a wider span. Refer to Systems Operation, Troubleshooting, Testing and Adjusting, "Bank valve (Grade Control) - Calibrate" for more information about the calibration procedure.STOP
NO - The setup of the laser transmitter is not stable.Repair: Refer to the Operation and Maintenance Manual, "Setup Procedures" in order to ensure the laser transmitter setup is stable. Repeat the valve calibration.
Repeat the valve calibration. Be sure to reset the upper and lower limits for the calibration procedure to a wider span. Refer to Systems Operation, Troubleshooting, Testing and Adjusting for more information about the calibration procedure.STOP