COVER AS 4935712 - Caterpillar

Table 6
Alternative     Default    
"YES"     "NO"    "PTO Cab Throttle RPM Limit"
This determines the engine rpm limit of the pedal position sensor for the cab accelerator and the cab set/resume switch when "PTO Configuration" is programmed to "Cab Switches" and the PTO on/off circuit is on. This parameter is intended to prevent engine overspeed when the dedicated PTO is used.
If the parameter is programmed to "Low Idle", the cab controls are ignored.
If the parameter is programmed to "Top Engine Limit" (TEL), the engine will operate to the programmed "Top Engine Limit".
If the parameter is programmed to "PTO Top Engine Limit", the engine will operate to the programmed "PTO Top Engine Limit".Note: "PTO Configuration" must be programmed to "Cab Switches" for this parameter to take effect. If "PTO Configuration" is programmed to "Remote Switches" or "Remote Throttle", the ECM will always ignore the cab controls when the PTO on/off circuit is on.
Table 7
Alternative     Default    
"Low Idle", "TEL" and "PTO TEL"     "TEL"    "PTO Kickout Vehicle Speed Limit "
This is the maximum vehicle speed for setting or maintaining a set engine rpm in PTO mode. PTO Mode is entered if the PTO on/off switch is on. (This uses input 1.) If the vehicle speed signal exceeds this value, the engine will not maintain the set engine rpm.
Table 8
Minimum     Maximum     Default    
2 km/h (1 mph)    
204 km/h (127 mph)    
2 km/h (1 mph)    "Torque Limit"
Illustration 1 g00628600
Operation of torque limit (1) Programmed torque limitThe parameter for the "Torque Limit" defines the maximum torque output of the engine during dedicated PTO operation. This parameter provides temporary protection of equipment. The "Torque Limit" of the engine is active when the circuit for the torque limit switch is on. The maximum value is the rated torque of the engine. The "Torque Limit" is programmable to N m (lb ft) of torque. Programming a value higher than the rated torque is limited by the ECM to rated torque. The torque limit is indicated by the dashed line in Illustration 1.
Table 9
Minimum     Maximum     Default    
135 N m (100 lb ft)    
2712 N m (2000 lb ft)    
2712 N m (2000 lb ft)    "PTO Shutdown Time"
The "PTO Shutdown Time" is the time (minutes) of engine operation with the PTO on/off circuit ON and no vehicle speed before shutting down. The timer will only count with no vehicle speed and the PTO on/off circuit turned on. The PTO shutdown timer will not begin counting if the engine is in Cold Mode. This parameter requires the "PTO Configuration" to be programmed to "Cab Switches", "Remote Switches", or "Remote Throttle" for the timer to function.Note: This feature does not shut down the vehicle's power. The ECM and the vehicle remain powered.
Table 10
Manufacturer / Model     Range     Default    
GM 530/540     3 minutes
to
1440 minutes     1440 minutes    
GMT-560     0 minutes
Other    "PTO Activates Cooling