COVER-SI ACCESS 4N2629 - Caterpillar

Table 1
Required Tools    
Part Number    Part Description    Qty    
1U-7316     Calibration Pin Group     1    The following instructions will ensure the proper orientation between the throttle lever and the throttle shaft for Type IV, Type V, Type VI, Type VII and some Type III Governors.A major feature that originated with the Type IV governor is the fact that the throttle lever is pressed onto the throttle shaft while the governor is running on the calibration bench. This change was made in order to help compensate for a stackup of internal tolerances in the governor, which sometimes made governor calibration difficult. Proper orientation of the throttle lever is important so the governor will pass the calibration procedure. Proper orientation of the throttle lever is also important so the governor will properly interface with the linkage during installation. Some linkage adjustment may still be necessary.Note: This procedure should be performed whenever a Type IV or Type V governor has had servicing or replacement of internal components. This procedure checks the orientation of