COVER-MODULE 5611221 - Caterpillar

Enable the Tool Indicator Display
Press the menu key (6) .
Press the down key (2) until "SERVICE OPTIONS" is highlighted on the fourth line of the monitor display.
Press the OK key (7) .
The "Enter Password" screen will be displayed with the number 0000.
Press the right key (1) until the fourth position 0000 is highlighted.
Press the up key (4) once. This will display the character 1 in the fourth position.
Press the OK key (7). "SERVICE OPTIONS" will be displayed on the first line of the monitor display.
Press the down key (2) until "PROPERTIES" is highlighted on the fourth line of the monitor display.
Press the OK key (7). "PROPERTIES" will be displayed on the first line of the monitor display.
Press the down key (2) until "TOOL INDICATOR" is highlighted on the fourth line of the monitor display.
Press the OK key (7). "TOOL INDICATOR" is highlighted on the first line of the monitor display.
Press the set key (5) in order to input a change. "ENABLE " should be displayed on the third line of the monitor display.
Press the cancel key (8) in order to exit the program.Select the Tool
Press the menu key (6) .
Press the down key (2) until "SELECT TOOL" is highlighted on the third line of the monitor display.
Press the OK key (7). The "Enter Password" screen will be displayed with the number 0000.
Press the OK key (7) again without entering a password.
Previously, the parameters for a "HAMMER" were set. Press the right key (1) or the left key (3) until "Hammer" is displayed on the second line of the monitor display.
Press the set key (5) in order to select this tool. The monitor will return to the display for normal operation. The screen will have the clock in the display.Adjust the Line Relief Valve
Adjust the mechanical setting for the line relief valve. This setting will be for the one-way flow function. This relief valve is located on the bottom of the manifold block. The manifold block is positioned on the inside of the boom foot that is next to the cab.
The mechanical line relief valve must be adjusted according to the tool manufacturer's recommended operating pressure.
This is a mechanical adjustment that will be made in addition to the software configuration.
Illustration 2 g00844467
(9) Line relief valveDisplay the Relief Pressure through the Monitor in order to Set the Line Relief Pressure
Illustration 3 g00843227
(1) Right key (2) Down key (3) Left key (4) Up key (5) Set key (6) Menu key (7) OK key (8) Cancel key
Illustration 4 g00844844
Location of shutoff valves
Make sure that the shutoff valves for the auxiliary control lines at the end of the stick are in the OFF position.
Start the engine.
Enter the service mode on the monitor display.
Press the menu key (6) .
Press the down key (2) until "SERVICE OPTIONS" is highlighted on the monitor display.
Press the OK key (7). Enter the password FFF2.
Press the down key (2) once in order to display F in the first position.
Press the right key (1) once in order to index the flashing character to