AVSPARE.COM
parts catalog

COVER 5C5154 - Caterpillar


5C5154 COVER Caterpillar parts 215, 215B, 215C
Rating:
52
Alternative (cross code) number:
CA5C5154
5C-5154
5C5154
Caterpillar 5C5154 COVER
Weight: 87 pounds 39 kg.

Buy COVER 5C5154 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 5C5154:

EXCAVATOR  215   215B   215C   Caterpillar
Number on catalog scheme: 22
  For full view, you need register

Information:


Illustration 1 g00481278
Schematic For Alarm Module (ALM)The alarm module (ALM) is available as an option. The ALM can be mounted on the instrument panel. The ALM can also be mounted at a distance as a remote annunciator. The ALM is used to satisfy requirements from customers and The National Fire Protection Association (NFPA) by annunciating the presence of a fault.The ALM communicates with the GSC by a serial data link. When the data link malfunctions, all of the indicators on the ALM that are controlled by the data link, flash at a rate of .5 Hz.Note: The maximum number of modules that can be connected to the serial data link is three. The maximum distance between a module and the GSC is 305 m (1000 ft). If these specifications are not met, there is a possibility for the ALM indicators to flash. Also, there is a possibility for the GSC to declare a diagnostic code of a CID 333. If the modules are not in compliance with the specifications, reduce the number of modules and/or shorten the distance to modules. Note: Faults are created when the harness connector (40 contact) is disconnected from the GSC during these troubleshooting procedures. Clear these created faults after the particular fault is corrected. In a properly operating system, when the harness connector is removed from the GSC, the following diagnostic codes are recorded.
CID 100 FMI 2 pressure sensor (engine oil)
CID 110 FMI 2 temperature sensor (engine coolant)
CID 111 FMI 3 fluid level sensor (engine coolant)
CID 190 FMI 3 speed sensor (engine)
CID 331 FMI 2 switch (engine control)
CID 336 FMI 2 switch (engine control)The following condition is a possible cause of a CID 333 FMI 4.
A short to the "B-" of the signal for the data is present.The GSC treats this diagnostic code as an alarm fault. Clear the diagnostic code from the fault log after troubleshooting is complete.Note: If a CID 333 FMI 4 is showing on the upper display and no alarm module is installed, check for a short. Check between the auxiliary terminal strip and the GSC.
Check the fault status (Active/Inactive).
Turn the ECS to OFF/RESET and then turn the ECS to STOP.
Press the alarm codes key.
Verify that a CID 333 FMI 4 is showing.
If the diagnostic code is not showing, enter the service mode and view the fault log (OP1). Verify that the diagnostic codes are showing. Expected Result: A CID 333 FMI 4 is showing as active or inactive. Results:
No - A CID 333 FMI 4 has not occurred (is NOT active and is NOT inactive). STOP.
Yes - A CID 333 FMI 4 is active. Proceed to 2.
Yes - A CID 333 FMI 4 is inactive. Proceed to 4.
Check the voltage of the signal for the data.
Turn the ECS to STOP.
At the ALM, measure the DC voltage from terminal 2 (positive meter lead) to terminal 7 (negative meter lead). Expected Result: The voltage that is measured should change constantly. The voltage should change within the range of 0 to 10

Caterpillar parts catalog:

Caterpillar parts catalog
215 EXCAVATOR 96L00001-00786 (MACHINE) POWERED BY 3304 ENGINE
215 EXCAVATOR 96L00787-UP (MACHINE) POWERED BY 3304 ENGINE
215 EXCAVATOR 14Z00001-00648 (MACHINE) POWERED BY 3204 ENGINE
215 EXCAVATOR 14Z00649-UP (MACHINE) POWERED BY 3204 ENGINE
215 EXCAVATOR 14Z00001-00648 (MACHINE) POWERED BY 3204 ENGINE
215B EXCAVATOR 2XC00001-UP (MACHINE) POWERED BY 3204 ENGINE
215 EXCAVATOR 57Y00001-UP (MACHINE) POWERED BY 3402 ENGINE
215 EXCAVATOR 95Z00001-UP (MACHINE) POWERED BY 3304 ENGINE
215B EXCAVATOR 9YB00001-UP (MACHINE) POWERED BY 3304 ENGINE
215B SA EXCAVATOR 4FC00001-UP (MACHINE) POWERED BY 3304 ENGINE
215B EXCAVATOR 9YB00001-UP (MACHINE) POWERED BY 3304 ENGINE
215B SA EXCAVATOR 4FC00001-UP (MACHINE) POWERED BY 3304 ENGINE
215 EXCAVATOR 57Y00001-UP (MACHINE) POWERED BY 3402 ENGINE
215B EXCAVATOR 9YB00001-UP (MACHINE) POWERED BY 3304 ENGINE
215B SA EXCAVATOR 4FC00001-UP (MACHINE) POWERED BY 3304 ENGINE
215C & 219 EXCAVATOR 4HG00001-UP (MACHINE) POWERED BY 3304 ENGINE
215D EXCAVATOR 9TF00001-UP (MACHINE) POWERED BY 3304 ENGINE
219D EXCAVATOR 5XG00001-UP (MACHINE) POWERED BY 3304 ENGINE


Parts cover Caterpillar catalog:

6N4414 COVER-FILTER BASE
120G, 12G, 130G, 14G, 16G, 16H NA, 215, 215B, 225, 235, 235B, 235C, 245, 245B, 24H, 30/30, 3114, 3116, 3126, 3126B, 3126E, 3176B, 3176C, 3196, 320 L, 3208, 322 FM L, 322C, 322C FM, 325, 3304, 3306, 34...
1P6367 COVER
120B, 120G, 12G, 12H, 12H ES, 12H NA, 130G, 140B, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 215, 215B, 215C, 225, 235, 235B, 330, 330 L, 3304, 3304...
9N5769 COVER-HOUSING
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 215B, 235, 235B, 330, 330 L, 3304, 3304B, 3306, 3306B, 3306C, 330B,...
1W4542 COVER-WATER PUMP
120B, 215B, 235, 235B, 330, 330 FM L, 330 L, 3304, 3304B, 3306, 3306B, 330B, 330B L, 350, 515, 517, 525, 527, 572G, 572R, 627B, 627E, 627F, 627G, 637E, 637G, 65C, 814F, 815F, 816F, 955L, 963, 966F, 96...
7N8374 COVER-PUMP
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 215, 215B, 235B, 3176C, 3196, 330, 330 FM L, 330 L, 3304, 3304B, 33...
4N3840 COVER
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140B, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 215, 215B, 235B, 330, 330 FM L, 330 L, 3304, 3304B, 3306, 330...
8N5929 COVER-WATER PUMP
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140B, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 215C, 235, 235B, 235C, 235D, 330, 330 L, 3304, 3304B, 3306, 3...
9G0004 COVER AS-TERMINAL
120G, 120H, 120K, 120K 2, 120M, 120M 2, 12G, 12H, 12K, 12M, 130G, 135H, 1390, 140G, 140H, 140K, 140K 2, 143H, 14H, 160G, 160H, 160K, 163H, 16H, 215, 215B, 2384C, 2484C, 24H, 24M, 2590, 30/30, 305.5, 3...
9M9439 COVER AS
120B, 12F, 16, 215, 215B, 225, 3114, 3116, 311C, 311D LRR, 312C, 312C L, 312D, 312D L, 312D2, 312E, 312E L, 315D L, 316E L, 318D2 L, 318E L, 319D L, 319D LN, 3208, 3304, 416B, 428B, 438B, 446B, 446D, ...
6A6492 COVER
215, 215B, 215C
5C8587 COVER
215, 215B, 215C
7J8014 COVER-FILTER
215, 613B, 613C, 613C II, 651, 768B, 769, 769C, 769D, 771C, 771D, 772, 772B, 773, 773B, 773D, 775B, 775D, 776C, 776D, 777, 777B, 777D, 784B, 784C, 785, 785B, 785C, 785D, 789, 789B, 789C, 789D, 793B, 7...
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.