COVER-FINAL DRIVE 5G5369 - Caterpillar

Table 5
Troubleshooting Test Steps Values Results
6. Clean the Components in the ARD Combustion Head
A. Remove the spark plug (5) from the ARD combustion head.
B. Clean the ground probe inside the ARD combustion head by running a 305-2389 Plug Bore Brush through the hole in the ARD combustion head. Run the brush through the hole several times.
C. Inspect the spark plug. Look for the following problems:
Spark Plug Gap Check the end of the spark plug to make sure that the spark plug gap is within specifications. The gap should be 2.67 0.762 mm (.105 0.030 inch).
Carbon Deposits - Use a nonmetallic cleaning pad to clean the spark plug.
Bent Probe - If the probe appears to be bent, replace the spark plug. Otherwise, install the original spark plug. Refer to the Specifications manual for the correct torque value.
Cracked Porcelain - If the porcelain appears to be cracked, replace the spark plug. Otherwise, install the original spark plug. Refer to the Specifications manual for the correct torque value.
The spark plug may be damaged if the spark plug is dropped. Do not install a spark plug that has been dropped.
Spark Plug Damaged
Result: The components are clean. The spark plug is not damaged.
Repair: Install the spark plug.
Proceed to Test Step 7.
Result: If the spark plug probe is bent, cracked, or has been dropped, replace the spark plug.
Illustration 5 g03777739
(6) Flame detection temperature sensor
Table 6
Troubleshooting Test Steps Values Results
7. Clean the Flame Detection Temperature Sensor
A. Remove the flame detection temperature sensor (6).
B. Clean the flame detection temperature sensor. Use a nonmetallic cleaning pad to clean the sensor.
Clean Sensor
Result: The components are clean. The flame detection temperature sensor is not damaged. Install the flame detection sensor.
Proceed to Test Step 8.
Result: The flame detection temperature is damaged. Replace flame detection temperature sensor.
Proceed to Test Step 8.
8. Check the ARD for Proper Operation
A. Reset all active codes and clear all logged codes. Use Cat ET to perform an "ARD Ignition Test" to verify that the problem is resolved.
The ARD Ignition Test cannot be performed if the DPF soot loading is above 80%. When the DPF soot loading is above 80%, the Manual DPF Regeneration must be performed using Cat ET.
Successful Test
Result: The test is successful.
Proceed to Test Step 11.
Result: The test is not successful.
Proceed to Test Step 9.
Result: The test is not successful. There are more codes.
Troubleshoot the additional codes. Refer to Troubleshooting for the correct procedure.
Verify that the problem is resolved.
Illustration 6 g02606408
(9) Fouled slot
Illustration 7 g02606409
(10) Acceptable soot accumulation
Table 7
Troubleshooting Test Steps Values Results
9. Inspect ARD Swirl Plate
A. Remove ARD head. Refer to Disassembly and Assembly, "Combustion Head Group (ARD) - Remove and Install - Clean Emissions Module" for the proper procedure to remove the ARD combustion head.
Soot accumulation is normal. Slot fouling is defined as more than 1/2 the inner row slots being blocked. Partially blocked inner row slots are normal and do not affect regeneration performance. Refer to Illustrations 6 and 7 to verify if the swirl plate is fouled.
B. Inspect the swirl