COVER A 5K929 5K5296 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
There have been issues with 435-4932 Temperature Sensor on the engine.Note: The temperature sensor is located in the Clean Emissions Module (CEM).Solution
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Caterpillaris investigating the root cause of these issues. To support the investigation, Caterpillar is requesting that the following steps are completed : -
Follow the correct troubleshooting procedure for any diagnostic codes that are displayed. Refer to Troubleshooting for more information.
Identify the temperature sensor that is believed to have an issue.
Verify that the issue is with the individual temperature sensor. The verification can be achieved by swapping the temperature sensor with the other temperature sensors. For example, DOC inlet, DPF or SCR.
The error code will follow the temperature sensor or change to the new position. Refer to Troubleshooting for more information.
Replace the temperature sensor that has the issue. Refer to Disassembly and Assembly for correct procedure.
Retain the removed temperature sensor for 30 days. The temperature sensor will be requested for return using the Send It Back (SIB) process.Note: Ensure that the temperature sensor packaged so that it is protected from damage.Submit the following information through "CPI Feedback" within the Service Information Management System:
Machine serial number
Machine hours
Diagnostic codes
Identify temperature sensor position
TIB media number M0096779
CPI number 421360