COVER 6B9278 - Caterpillar

Illustration 1 g06233530The following list contains some of the functions of the display module:
The diagnostic codes of the ECM systems are displayed.
The number of occurrences and the clock hour of the first and last occurrence are displayed for each of the events, active codes, and logged codes.
The definition for each logged diagnostic code and each event is displayed.
Illustration 2 g03862071
"Configurations" will not be visible in the Service Menu when Service Mode is disabled.
Some "Calibration" features (Factory Grade Control) will be hidden when Service Mode is not enabled.
Configurations
Illustration 3 g06233537The Configurations menu will appear only if the operator enters the Service mode password through the Service mode menu. Service Configurations allows the access to the following advanced settings:
Clock
AccuGrade: Enable/Disable/Automatic
Rear Implement: Not Installed/Ripper/Winch
Slope Assist: Installed/Not InstalledAccuGrade
Illustration 4 g03859474Rear Implement
Illustration 5 g06232499Diagnostics
Illustration 6 g03862101
(1) Fault Code
(2) Fault Description
Illustration 7 g03870476
Diagnostics screen
The "Diagnostics" menu option will show a complete list of all active events and the logged event codes and diagnostic codes.Codes and events that are contained in the system Diagnostics may be viewed at any time. The logged codes cannot be cleared until the Service Mode is enabled.Press the "OK" key while you are in the "Diagnostics" menu option to display the Diagnostic message screen.Each line that is listed contains the following information about that event or that code.Fault Code (1) - Component Identifier or Failure Mode Identifier (CID-EID)Fault Description (2) - Diagnostic code identifierCommunicating Active Faults or Events
When the diagnostic message is acknowledged, a predetermined length of time passes before the message screen will appear on the monitoring system display again. This interval is dependent upon the severity of the warning level. Consult the appropriate warning category for the proper instruction.ECM Summary
Illustration 8 g06232513The ECM Summary menu will display information for each ECM installed on the machine.This menu organizes the systems into the following five categories:
Engine
Machine
Implement
Product Link
DisplayThe following information will be displayed for each ECM:
ECM Serial Number
HW Part Number
SW Part Number
SW Release Date
SW DescriptionParameters
Illustration 9 g06232507The Parameters menu will display the value of several sensors. This menu may be useful for troubleshooting purpose. Scroll down to navigate through the different systems monitored.This menu organizes the systems into the following six categories:
Engine
Machine
Steering
Brake
Implement
Rear implementService Mode
To Enable Service Mode
Illustration 10 g03849586On the Service Mode page, highlight "Enable" and press the "OK" button. The aforementioned actions will move the check mark and enable Service Mode.When Service Mode is enabled, previously hidden Service Mode items will be viewable in the Service menu. The scroll bar will appear due to the two new items (Configurations and Calibration) that appear in the menu.