COVER 6T4435 - Caterpillar

Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause damage after prolonged operation. Inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Illustration 1 g00764405
Install three seal assemblies (7) to rotor (3). Lubricate the seals with clean hydraulic oil.Note: Apply clean grease to two bearings (2) .
If necessary, install two bearings (2). Lower the temperature of the bearings and place the bearings into position on rotor (3). Use an appropriate sized driver and a hammer in order to set the bearings.
Use a hydraulic press or a rubber mallet to install rotor (3) onto stator (1). Use care when you assemble the swivel in order to avoid damage to the seals.
Place ring (4) and locking plate (6) into position on stator (1) .
Apply 4C-9506 Retaining Compound to four bolts (5). Install the bolts to the swivel. Use a hammer and a punch in order to stake the tabs of locking plate (6) against the bolts.End By: Install the swivel to the work tool. Refer to Service Manual, "Swivel - Install".