COVER-SHIFT HOUSING 7M0840 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5F-4764 Pry Bar 1
B 6V-4062 Spring Compressor 1 Start By:
Remove the rocker shaft assembly and the pushrods.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Personal injury or death can result from the engine starting.The engine can start and injure persons working on or near the engine.Be sure the engine cannot be started while service work is being performed. This is very important when the engine is equipped with an Automatic Start Stop System.On engines equipped with an air starting system, close the air supply valve to the air starting motor before service work is begun.
Turn OFF the fuel supply to the engine.
Illustration 1 g02027452
Remove tube assembly (1) and tube assembly (2). Cap the fuel openings.
Illustration 2 g02027513
Remove locknut (8). Disconnect lever assembly (5) from control rod (7).
Remove bolts (6) and lever assembly (5).
Remove the bolt and clamp (3).
Do not pry the unit injector with a heel bar because damage (bending) to the fuel rack can occur. This will make unit injector replacement necessary.
Use Tooling (A) to loosen fuel inje