COVER 7W0750 - Caterpillar

Changing from low speed to high speed at full engine speed is possible. Directional changes at full engine speed are possible. However, if you are changing direction, reducing the machine speed and/or braking the machine is recommended. Proper braking will provide operator comfort and the maximum service life of the power train components. Keep a loaded bucket low to the ground. Stop the machine in order to avoid an unstable machine.
Lower the engine speed with the governor pedal.
Push the brake pedals (2) downward in order to slow the machine. Push the brake pedals (2) downward in order to stop the machine.
Move the transmission direction control lever (1) or move the direction control switch (3) (if equipped) to the desired direction. Rotate the transmission lever to the desired speed.
Release the brake pedals.
Increase the engine speed with the governor pedal.Secondary Steering (If Equipped)
If the primary steering indicator comes on and/or the action alarm sounds, steer the machine to a convenient location and stop the machine.The primary steering indicator indicates that the primary steering has failed. The alarm will also sound when the engine is running. The secondary steering indicator indicates that the secondary steering system is activated.Refer to Operation and Maintenance Manual, "Secondary Steering" for detailed information about the secondary steering function.Quick Coupler Function (if Equipped)
Disengaging the coupler pins will release the work tool from control of the operator.Serious injury or death may result from disengaging the work tool when it is in an unstable position or carrying a load.Place the work tool in a safe position before disengaging the coupler pins.
Inspect the quick coupler engagement before operating the machine.Serious injury or death may result from improperly engaged coupler.
Crush injury. Could cause serious injury or death. Always confirm that the quick coupler is engaged onto the pins. Read the Operator's Manual.
If your machine is equipped with the Fusion coupler, refer to Operation and Maintenance Manual, SEBU7617, "Fusion Wheel Loader Quick Coupler" for detailed operation information.Front Work Tool Coupler for Tools That Do Not Require Hydraulics
The switch has a locking tab. Pull the red button downward and press the bottom of the switch. Hold the switch in the downward position until the coupler pins disengage.Note: The switch for the Fusion coupler is a two-position switch. The switch will not return to the center position.
Tilt the coupler assembly forward.Make sure that the coupler assembly is below the level of the hooks on the work tool that will be attached.
Slowly, drive the machine forward. Align the hooks on the work tool with the coupler assembly.
Pull back on the lift lever in order to raise the coupler slightly. Raise the coupler until the coupler assembly contacts the hooks on the work tool and the work tool is lifted slightly.Make sure that the work tool is level from one side to the other side.
Tilt back the coupler assembly until the alignment bar of the work tool contacts the coupler.
Press the top of the switch and hold the switch for 3 seconds in order to engage