COVER AS-TRANSMISSION 8E2341 - Caterpillar

Obey all state and local laws governing the weight, width and length of a load.Remove the starting aid (ether) cylinder, if equipped.Make sure the cooling system has proper antifreeze if moving machine to a colder climate.Observe all regulations governing wide loads.
Investigate the travel route for overpass clearances. Make sure that there is adequate clearance for the machine that is being transported. This is especially important for machines that are equipped with a cab.Remove ice, snow, or other slippery material from the loading dock and from the truck bed before you load the machine onto the transport vehicle. This will help to prevent the machine from slipping in transit.Perform the following steps when you ship a machine:
Illustration 1 g00647986
Before you load the machine, chock the trailer wheels or the rail car wheels, as shown.
Illustration 2 g00644191
Lower the body. When you transport a machine without a body, suitable retainers must be installed on the hoist cylinders. Consult your Caterpillar dealer for more information.
When the machine is positioned on the transport machine, move the transmission control to the NEUTRAL position.
Move the parking and secondary brake control to the ENGAGED position.
Connect the steering frame locks.
Stop the engine.
Lower the front suspension. See Operation and Maintenance Manual, "Suspension - Lower".
Turn the battery disconnect switch to the OFF position. Remove the battery disconnect switch key.
Lock the cab door and attach any vandalism protection.
Secure the machine with tie-downs. Refer to the Operation and Maintenance Manual, "Lifting and Tying Down The Machine".
Remove the exhaust extension from the top of the muffler. Securely cover the exhaust opening in order to prevent the turbocharger from windmilling in transit.