COVER 8I2150 - Caterpillar

Illustration 11 g01397880
Click "OK". The Time and Geo Fence Setup Confirmation screen displays a red success message. Configuration History
Once a fence is configured with Setup Fence, the fence configuration is sent via satellite to the Product Link module on the machine. The fence state is "Pending" until the onboard configuration completes and a confirmation is received in the EquipmentManager software.The state of recently configured fences is displayed as an icon in the "Config History" field. The type of icon indicates one of the following states:Yellow Hour Glass - PendingGreen Check Mark - SuccessfulGrey Stop Watch - No new activityThe Pending or the Successful icons will be viewable for seven days after the configuration parameters have been sent to the Product Link module. After seven days, the "Successful" status will revert to the grey stop watch icon. If a pending configuration is not confirmed within the seven day time period, then Caterpillar recommends that a new configuration be sent.To view details of the configuration history, click the icon in the "Config History" column. The Time and Geographic Fencing Configuration History screen appears.Table 2 lists the descriptions of each of the fields that are in this screen.
Illustration 12 g01397882
Table 2
Field     Description    
Request Type     The type of fence that had been configured. Click the link to view configuration details.    
Fence Description     The description provided for the fence configured fence.    
Configuration Date     The date of the configuration:
Bold Date – Date the fence was configured in the EquipmentManager software.
Normal Date – Date Product Link accepted the fence configuration.    
State     The state of the configuration request:
Pending – Yellow hour glass
Successful within the last 7 days – Green check mark
Successful but older than 7 days – Grey stop watch    A configuration will remain in the "Pending" state if the machine cannot be reached via satellite. If this condition occurs, ensure that the master switch is closed and that the machine has a clear view to the sky. If Product Link is not able to receive the message, then the satellite network will continue to try to resend the message for up to one hour. If the message is not received within one hour, then the satellite network will retain the message for five additional days. The message delivery will be attempted again once Product Link is detected on the network and is sending and receiving messages. After five days, the configuration will no longer be retained and there will be no further attempts to deliver the message to the Product Link module.Enable and Disable
Once you have configured a machine to use time or geographic fences, remember that those fences are enabled by default. By opening the Enable/Disable screen, you can enable or disable the applied fences.In order to enable or to disable a time or geographic fence, use the following procedure:
Locate the "Equipment Information" section on the Time and Geographic Fencing screen.
Select the check box that is adjacent to the machine you wish to enable or