COVER AS-OIL COOLER 9L6103 - Caterpillar

Uninterruptible Power Supply: UPS 1000P (S/N: CZS1-UP) UPS 1200P (S/N: CZT1-UP)Introduction
The following information will aid the customer with the installation of the UPS 1200P with Paralleling.Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly. Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. If a tool, a procedure, a work method or operating technique that is not specifically recommended by Caterpillar is used, you must ensure that it is safe for you and for other people to use. You should ensure that the product will not be damaged or the product will not be made unsafe by the operation, lubrication, maintenance or the repair procedures that are used.
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Personal injury or death can result from improper assembly procedures.Do not attempt any assembly until you have read and understand the assembly instructions.
Acronyms
The following information is a list of the acronyms that may be used in this manual.ACCEL - AccelerometerATS - Automatic Transfer SwitchAWG - American Wire GaugeBFC - Bottom Field CoilBTU - British Thermal UnitCAN - Controller Area NetworkCOMM - CommutationCSHV - Flywheel CabinetDC - Direct CurrentDNI - Dual Network InterfaceDSB - Distributed Static BypassEPO - Emergency Power OffI/O - Input/OutputIGBT - Insulated Gate Bipolar TransistorLCD - Liquid Crystal DisplayMBP - Maintenance BypassMMU - Multiple Module UnitNEC - National Electric CodeNEMA - National Electrical Manufacturers AssociationPC - Personal ComputerPCC - Parallel Cabinet ControllerPWA - Printed Wire AssemblyREPO - Remote Emergency Power OffRPS - Rotor Position SensorSCR - Silicon Controlled RectifierSELV - Safety Extra Low VoltageSIO - System Input OutputSKiiP - Semikron Integrated Intelligent PowerTCP/IP - Transmission Control Protocol/Internet ProtocolTFC - Top Field CoilVAC - Voltage Alternating CurrentVDC - Voltage Direct CurrentOverview for Basic Installation
The following overview is the basic sequence for installing the parallel cabinet and the switchgear.
Create a plan for installation by using this manual and the dimension drawings that are provided.
Prepare the site.
Inspect the system. Unload the system. Unpack the system.
Place cabinets in locations that are described in this manual.
Ensure that the cabinets are secured to the floor.
Wire the system.
Install options as applicable.
Complete the installation checklist. Refer to Table