COVER 9M1675 - Caterpillar

Connection Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7574     Link Bracket     1    
B     138-7573     Link Bracket     3    
1U-9200 Lever Puller Hoist     1    Note: Cleanliness is an important factor. Thoroughly clean all parts with cleaning fluid before assembly. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g01173193
Use Tooling (B) and a suitable lifting device to position torque converter (8) onto transmission (9). The weight of torque converter (8) is approximately 170 kg (375 lb).
Illustration 2 g01173192
Install bolts (12). Tighten bolts (12) to a torque of 120 20 N m (89 15 lb ft).
Illustration 3 g01173190
Install bolts (11) .
Remove Tooling (B) .
Illustration 4 g01173188
Attach Tooling (A) and a suitable lifting device to torque converter (8). Use Tooling (A) to reposition torque converter (8), transmission (9), and transfer gears (10). The combined weight of torque converter (8), transmission (9), and output transfer gears (10) is approximately 816 kg (1800 lb).
Illustration 5 g01173187
Remove Tooling (A) from torque converter (8) .
Illustration 6 g01173186
Install bolts (7). Tighten bolts (7) to a torque of 120 20 N m (89 15 lb ft).
Illustration 7 g01173184
Install tube assembly (6) .
Illustration 8 g01173182
Position transmission oil pump (1) and install bolts (3) .
Install tube assembly (4) .
Connect harness assemblies (2) and (5) .End By: Install the torque converter, the transmission, and the output transfer gears.