COVER AS 9Y9333 - Caterpillar

Illustration 19 g00559412
Rotate converter stator (32) . Use a screwdriver in order to remove retaining ring (35) from converter stator (32) .
Use Tooling (B) (not shown) and a suitable press in order to remove freewheel cam (40) from converter stator (32) .
Illustration 20 g00493823
Install Tooling (A) onto housing (7) . Attach Tooling (A) to a suitable lifting device and a hoist. Use Tooling (A) and the hoist in order to remove housing (7) and converter impeller assembly (41) from output shaft (31) . Use caution while the housing is lifted. The components that are unfastened may fall. The weight of housing (7) and converter impeller assembly (41) as a unit is 80 kg (176 lb).
Illustration 21 g00494001
Remove thrust bearing (42) .
Illustration 22 g00495825
Remove eight bolts (43) in order to remove impeller hub assembly (44) from converter impeller assembly (41) .
Remove two hex socket screws (47) and the retaining washers. Remove wear sleeve (45) and thrust race (46) from impeller hub assembly (44) .
Illustration 23 g00494017
Rotate housing (7) . Place wood blocks under converter impeller assembly (41) . Remove 24 bolts (48) and the washers in order to remove converter impeller assembly (41) from housing (7) .Note: If necessary, install four equally spaced bolts. Gently tap on the bolts with a soft faced hammer in order to remove the converter impeller assembly.
Illustration 24 g00494822
Remove bolts (50) from pump drive gear (49) in order to remove pump drive gear (49) from converter impeller assembly (41) .
Illustration 25 g00494054
Use a brass drift in order to remove wear sleeve (51) from converter impeller assembly (41) .
Illustration 26 g00494080
Remove six bolts (52) and split washer (54) in order to remove freewheel race (53) from stator carrier (56) .
Remove two ring seals (55) from stator carrier (56) .
Illustration 27 g00494123
Remove bolt (57) , retainer (58) and the O-ring seal in order to remove yoke (59) from the output shaft.
Illustration 28 g00494141
Remove 11 bolts (60) in order to remove fluid distributor (61) and the gasket from stator carrier (56) .
Remove lip seal (62) from fluid distributor (61) .
If necessary, remove O-ring plug (63) and the O-ring seal from fluid distributor (61) .
Illustration 29 g00494681
Install Tool (E) onto output shaft (31) . Attach Tool (E) to a suitable lifting device and a hoist. Use Tool (E) and the hoist in order to remove output shaft (31) from stator carrier (56) . The weight of output shaft (31) is 25 kg (55 lb).
Remove Tool (E) from output shaft (31) .
Illustration 30 g00494202
Remove two ring seals (64) from ring carrier (67) . Remove ring seal (66) from ring carrier (65) .
Remove ring carrier (65) , ring carrier (67) , and ball bearing (68) from output shaft (31) .
Illustration 31 g00494747
Remove retaining ring (70) and inner bearing (69) from stator carrier (56) .