AVSPARE.COM
parts catalog

CRADLE A 0876717 - Caterpillar



0876717 CRADLE A Caterpillar parts CRADLE
Rating:
61
Alternative (cross code) number:
CA0876717
087-6717
0876717
Caterpillar 0876717 CRADLE A

Buy CRADLE A 0876717 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 4C-4089 Hydraulic Platform Jack 1
4C-4090 Handling Tool Gp 1 Start By:
Remove the wheel. Refer to Disassembly and Assembly, "Wheel (Final Drive) - Remove and Install".
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, all hoses, and all tubes.
Drain the oil from the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic Oil and Filters - Change" for the correct procedure.
Illustration 1 g02476051
Remove the bolts and covers (1).
Illustration 2 g02476064
Remove clamps (3) and disconnect hose assemblies (2) and hose assemblies (5).
Disconnect harness assembly (4).
Illustration 3 g01059136
Remove the bolts and shield (6) from planetary (7). Note: Put orientation and location marks on the planetary and on the frame for installation purposes.
Use Tooling (A) and support planetary (7). Remove bolts (8). Use Tooling (A) and remove planetary (7) and the propel motor from the machine. The weight of the planetary and the propel motor is approximately 310 kg (685 lb). Installation Procedure
Install planetary (7) in the reverse order of removal. End By:
Install the wheel. Refer to Disassembly and Assembly, "Wheel (Final Drive) - Remove and Install".


Parts cradle Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.