CRANKSHAFT KIT 0R5043 - Caterpillar

Introduction
The problem that is identified below does not have a permanent solution. Until a known permanent solution is known, use the solution that is identified below.Problem
When a AccuGrade Dual GPS system is tracking the GPS satellite SV32, the right GPS receiver is unable to calculate an RTK Fixed position. This causes a "No GPS Right" error to be reported. This problem is caused by an error in the firmware for the GPS receiver.Solution
To resolve this issue, SV32 must be disabled in the GPS receiver. Caterpillar has created a "generic" .cfg file that can be loaded to the receiver to disable SV32. In order to load the file, complete the following steps:
The "generic" .cfg file can be obtained in one of three ways:
Dealer Solutions Network
Knowledge Network "https://kn.cat.com/know.cfm?id=190423"
CPI Issue Number 187814
Copy the "sv32disable.cfg" file to the root directory of the data card.
Insert the data card into the display. If required, restart the display in Service mode by holding down on the OK key during power up.
Press the Menu Key. The "Setup Menu - Configuration" menu appears.
Illustration 1 g01484254
Select "GPS Receiver Configuration". The "GPS Receiver Configuration" dialog appears.
Select the configuration file that you saved on the data card and press the