CRANKSHAFT GP 2243250 - Caterpillar

    Generator Over excitation     X     X    
1122     Generator Bearing Temperature #1         X    
1124     Generator Winding Temperature #1         X    
1125     Generator Winding Temperature #2         X    
1126     Generator Winding Temperature #3         X    
1237     Emergency Shutdown Override Mode Active Warning     X     X    
1239     Ruptured Fuel Basin-Primary Tank     X     X    
1383     Unexpected Engine Shutdown         x    
1664     Engine Failure to Start Shutdown         X    
2433     Right Exhaust Temperature         X    
2434     Left Exhaust Temperature         X    
2436     Generator Frequency         X    
2440     Generator Voltage         X    
2448     Generator AC Current         X    
2452     Generator Reverse Power (kW)         X    
2456     Generator Reactive Power (VAR)         X    
2648     Service Interval Warning         X    
4000     Air Shutoff Damper Close     X     X    
4001     ATS in Normal Position     X     X    
4002     ATS in Emergency Position     X     X    
4003     Battery Charger Failure     X     X    
4004     Generator Breaker Closed     X     X    
4005     Utility Breaker Closed     X     X    
4006     Engine in Cool Down         X    
4007     Generator Control Not in Auto         X    
4028     Earth Fault     X     X    
4029     Earth Leakage     X     X    
User Defined Input #1     Range
701-716     X        
User Defined Input #2     Range
701-716     X        
User Defined Input #3     Range
701-716     X        
User Defined Input #4     Range
701-716     X        
User Defined Input #5     Range
701-716     X        
User Defined Input #6     Range
701-716     X        
User Defined Input #7     Range
701-716     X        
User Defined Input #8     Range
701-716     X        
User Defined Input #9
    Range
701-716     X        
User Defined Input #10     Range
701-716     X        
User Defined Input #11     Range
701-716     X        
User Defined Input #12     Range
701-716     X        
( 1 ) Input configured as "Emergency Stop Shutdown" (SPN 970) will not perform a shutdown when activated. Use only to create an event log message in the EMCP 3 if desired.Outputs
The discrete I/O module has eight "Form C" relay outputs. Each output can be configured to signal one of many possible events. Each output can be configured for either general events or for specific events. The Cat ET Service Tool (CST) is used in order to configure the discrete I/O module outputs.For general