CRANKSHAFT AS 2378308 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5F-4764 Pry Bar 1 Start By:
Remove the rocker shaft assembly and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft Assembly and Push Rods - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00903832
Remove bolt (1) and the clamp.
Remove bolt (2) and the clamp.
Disconnect harness assembly (3).
Illustration 2 g00903932
Use Tooling (A) to remove electronic unit injector (4).
Remove fuel / fluids from the cylinder. ! Turning over (cranking) an engine with an injector removed could result in personal injury or death from fluids escaping at high velocity.