CRANKSHAFT AS 2410221 - Caterpillar

Illustration 1 g03437936
Typical Example
Table 1
Callout Quantity Part Specification Description
1 - Connecting rod bearings Refer to the Specifications Module, "Connecting Rod Bearing Journal" topic for information on the connecting rod bearings.
2 - Thrust washers Standard thickness 2.26 mm to 2.31 mm (0.089 inch to 0.091 inch)
Oversize thickness 2.45 mm to 2.50 mm (0.097 inch to 0.098 inch)
3 - Main bearings Refer to the Specifications Module, "Main Bearing Journal" topic for information on the Main bearings.
4 - Crankshaft gear Maximum permissible temperature of the gear for installation on the crankshaft 180 °C (356 °F)
The timing mark is toward the outside of the crankshaft when the gear is installed on the crankshaft. Note: After a crankshaft has been reconditioned, the crankshaft must be rehardened. After a nitrocarburised crankshaft has been reconditioned, the nitrocarburised crankshaft must be rehardened. If the crankshaft has been nitrided for at least 60 hours, the crankshaft can be ground undersize 0.25 mm (0.010 inch) without rehardening. An induction hardened crankshaft does not need rehardening after machining. Inspect the crankshaft for cracks before machining and after machining.Note: Turbocharged engines and turbocharged aftercooled engines have the nitrocarburised crankshaft. Naturally aspirated engines have the induction hardened crankshafts.
Table 2
Callout Quantity Part Specification Description
5 - Crankshaft end play End play of the crankshaft 0.05 mm to 0.38 mm (0.002 inch to 0.015 inch)
Maximum crankshaft end play 0.51 mm (0.020 inch)
6 - Connecting rod journal Refer to the Specifications Module, "Connecting Rod Bearing Journal" topic for more information on the connecting rod bearing journals and connecting rod bearings.
7 - Main bearing journal Refer to the Specifications Module, "Main Bearing Journal" topic for information on the main bearing journals and for information on the main bearings