CRANKSHAFT ASSEM. 4S7436 - Caterpillar

Note: Refer to Special Instruction, REHS1841, "General Welding Procedures" prior to performing any welding.Note: Remove all paint, dirt, oil, debris, or other contaminants from the area to be welded prior to completing any welding.
Tack weld to bracket assemblies (1) on the body and canopy assembly.
Use an 8 mm (0.315 inch) all around fillet weld to secure bracket assemblies (1) to the frame.Note: All finish welds must be inspected for any defects. Note: Refer to Special Instruction, REHS1841, "General Welding Procedures" for inspection instructions.
Reinstall any hardware or machine components that were removed in Step 1.
As needed, repaint the areas.
Install the warning films. Refer to ""Warning Films"" for additional information.Dual Slope Body
Illustration 9 g03391917
Typical view (1) 293-4578 Bracket As
Illustration 10 g03391918
Typical view of the bottom of the 261-0091 Body and Canopy As (1) 293-4578 Bracket As
Locate five bracket assemblies (1) onto the bottom of the body and canopy assembly. Refer to the correct Illustrations above and Table 3 for the locations.As needed, remove and retain any hardware or machine components that may interfere with welding on the body and canopy assembly.Note: Ensure that bracket assemblies (1) are oriented as shown in the above Illustrations.
Table 3
Dimension     261-0091 Body and Canopy As    
A    
215 3 mm (8.46 0.118 inch) Two places    
B    
433 3 mm (17.05 0.118 inch)    
C    
47 3 mm (1.85 0.118 inch) Three places    
D    
265 3 mm (10.43 0.118 inch) Two places    
E    
47 3 mm (1.85 0.118 inch) Two places    Note: Refer to Special Instruction, REHS1841, "General Welding Procedures" prior to performing any welding.Note: Remove all paint, dirt, oil, debris, or other contaminants from the area to be welded prior to completing any welding.
Tack weld to bracket assemblies (1) on the body and canopy assembly.
Use an 8 mm (0.315 inch) all around fillet weld to fully secure bracket assemblies (1) to the frame.Note: All finish welds must be inspected for any defects. Note: Refer to Special Instruction, REHS1841, "General Welding Procedures" for inspection instructions.
Reinstall any hardware or machine components that were removed in Step 1.
As needed, repaint the areas.
Install the warning films. Refer to ""Warning Films"" for additional information.Warning Films
Illustration 11 g03359590
(2) 299-5775 Film (3) 299-5776 Film (4) 299-5777 Film (5) 299-5778 Film
After the welds have been inspected and painted, install one of the following warning films:
(2) 299-5775 Film
(3) 299-5776 Film
(4) 299-5777 Film
(5) 299-5778 Film Note: Films should be installed 50 to 75 mm (2 to 3 inch) from bracket assemblies (1) .Note: Customers in North America should use either film (2) or film (4). All other customers should use film (3) or film (5) .Register the Retrofit
When performing a retrofit installation, record the vital information in Table 4. Note: If the procedure is performed by the customer, ask the customer to record the proper information.
Table 4
Repair Date        
Product