CROSS UNION 0832465 - Caterpillar

Table 1
Required Tools    
Part     Quantity    
Minimum
1.22 m (4 ft) Straightedge     2    
To prevent personal injury when checks are made while the machine is in operation, make sure only approved personnel are on the machine. Keep other personnel off the machine and in view of the operator. Make sure checks are done in an open area.
Illustration 1 g00905683
The Tie Rod is Located on the Right Side and the Left Side of the Front Drive Axle. (1) Tie rod (2) Yoke assembly
Illustration 2 g00891414
With the tires in the CENTER position, clamp a straightedge on each side of the axle group. This should be done with the straightedge parallel to the ground.
Illustration 3 g00891416
Measure dimension (A) and dimension (B). Compare the dimensions. The steering alignment is correct when dimension (A) is less than dimension (B) by 0 to 3.20 mm (0 to 0.125 inch).
If the dimension is not correct, an adjustment needs to be made.
Leave the test equipment in place.
Illustration 4 g00891420
(3) Locking nut (4) Axle housing (5) Nut (6) Nut (7) Yoke assembly
Loosen locking nut (3) from axle housing (4) .
Loosen nut (5) and nut (6). Loosen the nuts on both sides of tie rod (1) .
Adjust the steering alignment by adjusting yoke assembly (7). You will need to turn the yoke assembly clockwise or counterclockwise on each side of tie rod (1). This is dependent on the measurements that were obtained in the test.
Recheck and adjust the steering alignment. Make sure that dimension (A) is less than dimension (B) by 0 to 3.20 mm (0 to 0.125 inch).
Reattach the tie rod and locking nuts.
Remove the test equipment.
Refer to Systems Operation, KENR3108, "Machine Electronic Control System" for information on the calibration procedures for the MAC-14.