CROWN 8J0118 - Caterpillar

Horn - Push the knob to sound the horn. Use the horn to alert or signal personnel.Instrument Panel Dimmer Switch
ON/OFF Switch - Press the top of the switch to dim the panel lights. Press the bottom of the switch to increase the illumination.Roading Switch (If Equipped)
ON/OFF Switch - Press the bottom of the switch to isolate the body hoist control before roading the machine.Heating Controls
Fan Speed Switch (1) - This switch controls the three speed heater fan. OFF - The heater fan is OFF. Heating - Turn the speed switch clockwise to operate the heating. First Speed Second Speed Third Speed Temperature Control (2) - With the fan speed switch turned clockwise from OFF to select HEATING turn the control further into the red zone to progressively increase the temperature.Air Conditioning Controls (If Equipped)
Fan Speed Switch (1) - This switch controls the three speed air conditioner fan. OFF - The air conditioner fan is OFF Air Conditioning - Turn the speed switch counterclockwise to operate the air conditioning. First Speed Second Speed Third Speed Temperature Control (2) - With the fan speed switch (1) turned counterclockwise from OFF to select AIR CONDITIONING turn the control further into the blue zone to progressively reduce the temperature.Seat Adjustment
Adjust the seat at the beginning of each shift or when changing operators. Seat adjustment should allow full travel of the pedals when the operator is seated against the seat back.Contour Seat
Pull lever (1) UP to adjust the angle of the seat back.Pull lever (2) to adjust the seat cushion to the desired angle.Pull lever (3) to adjust the fore-aft position of the seat.Pull lever (4) UP to adjust the seat height.Fold out the handle and turn wheel (5) until the line on indicator (6) corresponds with the operators weight in kg. 1 kg = 2.2 lb.Adjust the seat suspension damping using control (7). Move the control to increase (+) or decrease (-) the amount of damping.Turn lever (8) to adjust the amount of lower back support required.Air Suspension Seat (If Equipped)
The height and suspension setting of the seat is controlled by a switch on the seat base which operates an electrically driven compressor. This system will operate only when the engine start switch key is in the ON position Move switch (1) up to raise the seat. Move the switch down to lower the seat. The switch will return to the center position when released.Periodically check the seat setting when the machine is stopped with the parking brake engaged, and re-adjust if necessary.Pull up the seat cushion tilt lever (2), to adjust the seat cushion to the desired angle. Release the lever to lock the seat cushion.Pull up the fore-aft lever (3) to move the seat forward or back to the desired position. Release the lever to lock the seat in place.Pull up the seat recline lever (4) to move the seat back to the desired position. Release the lever to lock the seat in position. Pull up to remove backrest