CUP 0869066 - Caterpillar

Product Identification Number (PIN)
Illustration 1 g03422036
The Product Identification Number (PIN) plate is located at the rear of the machine on the left side. The plate may have the following information:
Illustration 2 g02436556
Manufacturer Name and Address ____________________Model number (A) ____________________Product Identification Number (B) ____________________Service Information Plate (C) ____________________Year of Manufacture Plate (If Required) (D) ____________________CE Plate (If Required) (E) ____________________Country of Origin Info Plate (If Required) (F) ____________________
Illustration 3 g02218956
Engine Information and Serial Number Plate____________________Certification
ROPS/FOPS Structure
This message is positioned on the ROPS on the left side of the machine above the door.
Illustration 4 g01212098
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. This will void the certification. Consult your Cat dealer to determine this structure's limitations without voiding its certification.
This machine has been certified to the standards that are listed on the certification film. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification film.Refer to Operation and Maintenance Manual, "Guards (Operator Protection)" for more information.European Union
Illustration 5 g01880193
This plate is positioned on the bottom left side of the plate for the PIN.Note: The CE plate is on machines that are certified to the European Union requirements that were effective at that time.For machines compliant to 2006/42/EC, the following information is stamped onto the CE plate. For quick reference, record this information in the spaces that are provided below.
Engine Power Primary Engine (kW)____________________
Engine Power for Additional Engine (If Equipped) ____________________
Typical Machine Operating Weight for European Market (kg)____________________
Year of Construction____________________
Machine Type ____________________Product Link
If equipped, this message is used to verify the certification of the Product Link as an RF transmitter. The following specifications are provided to aid in ensuring compliance with all local regulations:
Table 1
Operating frequency range     148 to 150 MHz    
Transmitter power     5 W    This message is located on the control group for the Product Link. The control group is located on the top of the cab.
Illustration 6 g01261742
This machine is equipped with a Cat Product Link radio communication device which must be deactivated within 6.0 m (20 ft) of a blast zone. Failure to do so could result in serious injury or death.
If the machine is required to work within 6 m (20 ft) of a blast area, power to the Product Link module must be disconnected.Consult your Cat dealer with any questions that concern the operation of the Product Link in a specific country.