CUP-BEARING 1M6573 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5P-3975 Rubber Lubricant - Start By:
Remove the fuel transfer pump.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct draining and filling procedures.
Illustration 1 g01964858
Remove tube assemblies (1) and the brackets.
Remove bolts (2), (3), and (5). Remove adapter (4). Remove the gaskets from adapter (4). Disconnect the elbow. Remove the O-ring seal from the elbow.
Illustration 2 g01964916
Remove bolts (6) and disconnect the elbow. Remove the O-ring seal.
Attach a suitable lifting device to engine oil pump (7). The weight of engine oil pump (7) is approximately 45 kg (99 lb).
Remove bolts (9) from the connector. Remove bolts (8) and engine oil pump (7) from the pump adapter. Remove the O-ring seal from the connector. Remove the O-ring seal from engine oil pump (7). Installation Procedure
Install engine oil pump (7) in the reverse order o