CUP 2D0511 - Caterpillar

Remove Tooling (A) from the top of the cab. Repeat this procedure for each of the remaining three corners.
Illustration 9 g00843961
Connect ground strap (28) .
Install nut (29) and the washer.
Illustration 10 g00843957
Connect parking brake cable (25) to bracket (27) .
Tighten nut (26) .
Illustration 11 g00843951
Connect parking brake cable (25) to bracket (24) .
Install pin (23) and cotter pin (22) .
Illustration 12 g00843947
Install service brake (21). Install two nuts (20) and the washers.
Illustration 13 g00843935
Install metering pump (19). Install four bolts (18) and the washers.
Illustration 14 g00843931
Connect bracket (17) to cab (1) .
Install bolt (16), the washer, and the clip.
Illustration 15 g00843929
Connect two brackets (15) to cab (1) .
Install two bolts (14) and the washers.
Illustration 16 g00843915
Connect two hoses (13) to the back of the washer fluid bottle.
Illustration 17 g00843912
Top of Hydraulic Tank
Install wire tie (12) .
Illustration 18 g00843909
Right Side of Cab
Connect five hose assemblies (9) .
Connect hose assembly (10) .
Install three bolts (11), the washers, and the clips.
Illustration 19 g00843900
Install pin (8) to the door latch, as shown.
Illustration 20 g00843890
Back of Cab
Connect six wiring harnesses (6) to the back of cab (1) .
Install bolt (7), the washer, and the clip.
Illustration 21 g00843888
Back of Cab
Connect hose assembly (4) and (5) to the back of cab (1) .
Illustration 22 g00843883
Back of Cab
Install bolt (2), the washers, and the clip.
Connect two heater hoses (3) to the back of cab (1) .End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".