CUP-BEARING 7K5448 - Caterpillar

System Configuration Parameters are parameters that affect emissions, power of the engine, and other features. The parameters are programmed at the factory. In most cases, the parameters do not need to be changed. The System Configuration Parameters must be reprogrammed if an Electronic Control Module (ECM) is replaced and/or the engine rating is reprogrammed. System Configuration Parameters do not need to be reprogrammed if the Personality Module is replaced. Proper values for these parameters are available on the Caterpillar Electronic Technician (ET). Certain Configuration Parameters are also stamped on the Engine Information Plate.Note: If the parameters that are protected with the factory passwords are changed, the Caterpillar warranty may be voided.
Engine Serial Number
The engine serial number should be programmed to match the engine information plate. The serial number is not programmed on a new ECM.FRC Offset Value
The ECM determines a value that is based on the atmospheric pressure. The value is used to adjust the fuel ratio control. This will control the exhaust while the engine accelerates. An offset value of 25 may be used to adjust for customer preference, fuel quality, or other factors that affect engine performance.Note: This parameter may not be available on all applications.Rated Fuel Position
This parameter is used to set engine power. A Factory Password is required to change this setting.
Table 1
Minimum     Default     Maximum    
Minimum Rack     Engine Dependent     Engine Dependent    Low Idle
The parameter defines the lowest rpm level.
Table 2
Minimum     Default     Maximum    
810 rpm     900 rpm     1450 rpm    Cooldown Speed
This parameter defines the engine rpm level when the ECS is placed in the STOP position.
Table 3
Minimum     Default     Maximum    
810 rpm     810 rpm     1800 rpm    Cooldown Period
This parameter defines engine operation at the cooldown speed. Programming this parameter to 0 will disable this function.
Table 4
Minimum     Default     Maximum    
0 minutes     0 minutes     30 minutes    Prelube Time
The parameter sets the amount of time for prelubrication. Programming this parameter to 0 will disable this function.
Table 5
Minimum     Default     Maximum    
0 seconds     0 seconds     210 seconds    Crank Duration
The crank duration determines when the starting motors will be energized. The crank duration determines when the starting motors will be disengaged. Programming this parameter to 0 will prevent the ECM from engaging the starting motors.
Table 6
Minimum     Default     Maximum    
0 seconds     0 seconds     60 seconds    Cranking Cycles
This parameter is the total number of crank cycles that can be performed.
Table 7
Minimum     Default     Maximum    
0     0     10    Crank Terminate Speed
This parameter determines when the starting motor will disengage.
Table 8
Minimum     Default     Maximum    
100 rpm     400 rpm     500 rpm    Air Shutoff
Programming the parameter to "OFF" will disable the air shutoff. This parameter should be programmed to "OFF" if the function is not