CUP-BEARING 8H0901 - Caterpillar

Refer to this Operation and Maintenance Manual, "Fluid Recommendations" for information about the fluids which are acceptable for this engine.Note: Refer to Special Publication, SEBU6251, "Caterpillar Commercial Diesel Engine Fluids Recommendations" for additional information.Lubricant Refill Capacity
Table 1
C27 And C32 Generator Sets
Approximate Refill Capacities
Compartment or System Liters Quarts
Engine Crankcase Standard Sump
Standby Generator Set 68 (72)
Engine Crankcase Standard Sump 99 (105)
Engine Crankcase Deep Sump 186 (197) Cooling System
Coolant Capacities
To maintain the cooling system, the total cooling system capacity must be determined. The total cooling system capacity will vary between individual installations. The total cooling system capacity can include the following components: engine, expansion tank, radiator, and piping.Refer to the specifications that are provided by Caterpillar or the OEM of the installation. Record the total cooling system capacity in the appropriate Table.
Table 2
C27 and C32 Engine
Approximate Refill Capacities
Compartment or System C27 C32
Standard Ambient High Ambient Generator Sets with Cat Enclosures(1) Standard Ambient High Ambient Generator Sets with Cat (1) Enclosures
Engine Only 55 L (14.5 gal) 55 L (14.5 gal) 55 L (14.5 gal) 55 L (14.5 gal) 55 L (14.5 gal) 55 L (14.5 gal)
External System (OEM)(2) 43 L (11.3 US gal) 58 L (15.3 US gal) 50 L (13.2 gal) 35 L (9.25 US gal) 60 L (16 US gal) 63 L (16.7 US gal)
Total Cooling System(3) 98 L (26 US gal) 113 L (30 US gal) 105 L (27.8 US gal) 90 L (23.75 US gal) 115 L (30.5 US gal) 118 L (31.1 US gal)
(1) Also used for open generator sets that are International Building Code (IBC) compliant and pre-approved for California Office of Statewide Health Planning and Development (OSHPD) special seismic design. This was the standard radiator offered prior to mid-2017.
(2) The External System includes a radiator or an expansion tank with the following components: heat exchanger, aftercooler, and piping. The capacity shown is for cooling systems provided from the Caterpillar factory. If a different OEM cooling system is being used, cross out the factory value, and enter the correct value per OEM specifications.
(3) The Total Cooling System includes the capacity for the engine plus the capacity for the external system. Enter the total in this row.