CUP-BEARING 9D0994 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     9S-9082     Engine Turning Tool     1    
B     FT-1322     Lever Assembly     1    
C     5P-0144     Fuel Line Socket     1    
D     6V-2156     Link Bracket     3    
E     8S-9906     Ratchet Puller     1    
Install a new spacer plate gasket. Refer to Disassembly and Assembly, "Spacer Plate - Remove and Install".
Thoroughly clean the bottom surface of the cylinder head. Install a new cylinder head gasket and water seals. Do not use any adhesives.
Illustration 1 g00793033
Attach Tool (D) to the cylinder head. Use a hoist in order to install the cylinder head on the engine. The weight of the cylinder head is 172 kg (379 lb). Apply clean engine oil to the threads of all the cylinder head bolts. Install bolts (1). Do not tighten the bolts.
Use the following procedure in order to tighten the cylinder head bolts.
Illustration 2 g00793136
Tightening sequence for cylinder head bolts
Tighten bolt (1) through bolt (20) in a numerical sequence to a torque of 280 27 N m (207 20 lb ft).
Tighten bolt (1) through bolt (20) in a numerical sequence to a torque of 440 20 N m (325 15 lb ft).
Tighten bolt (1) through bolt (20) again in a numerical sequence to a torque of 440 20 N m (325 15 lb ft).
Install the rocker arm groups. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod Install".
Tighten bolts (21) through bolt (26) in a numerical sequence to a torque of 280 27 N m (207 20 lb ft).
Tighten bolt (21) through bolt (26) in a numerical sequence to a torque of 440 20 N m (325 15 lb ft).
Tighten bolt (21) through bolt (26) again in a numerical sequence to a torque of 440 20 N m (325 15 lb ft).
Illustration 3 g00793726
Install bolt (2) and support (3) .
Illustration 4 g00793766
Install bolt (4) and support (5). Install the remaining ten bolts and the supports along the intake side of the cylinder head. Tighten the twelve bolts to a torque of 43 7 N m (32 5 lb ft).
Install bolt (6) to the timing advance housing.
Illustration 5 g00793786
Put the gasket in position. Install bolts (7) and water lines group (8) .
Install the bolt and locknut (9) .End By: Install the turbochargers.