CUP AS-AIR CLEANER 9Y7773 - Caterpillar

Record the following information before you change any parameter.
Table 1
System Configuration Parameters
Parameter Present Value
Personality Module Interlock
Electronic Control Module (ECM)
Serial Number
Engine Serial Number
Equipment ID
Full Load Setting (FLS)
Full Torque Setting (FTS)
"Fuel Ratio Control Offset (FRC)"
"Rated Fuel Positon (mm)"
Fuel Correction Factor (%)
Low Idle (rpm)
Droop (%)
"Governor Gain Factor"
"Governor Minumum Stability Factor"
Acceleration Delay on start-up (sec)
Acceleration Rate (rpm/sec)
Programmable Torque Scaling
"Engine Cooling System Configuration"
Cold Cylinder Cutout
"Cooldown Engine Speed (rpm)"
"Engine Cooldown Duration (min)"
"Engine Prelube Duration (sec)"
"Crank Duration (sec)"
"Maximum Number of Crank Cycles"
"Crank Terminate Speed (rpm)"
"Total Tattletale"
Injector Code (1)
Injector Code (2)
Injector Code (3)
Injector Code (4)
Injector Code (5)
Injector Code (6)
Injector Code (7)
Injector Code (8)
Injector Code (9)
Injector Code (10)
Injector Code (11)
Injector Code (12) Record the following information from the engine monitoring system.
Table 2
Engine Monitoring System
Warning Trip Point Warning Delay Time Derate Trip Point Derate Delay Time Shutdown Trip Point Shutdown Delay Time
Low System Voltage
Low Oil Pressure
High Coolant Temperature
Low Coolant Temperature
Engine Overspeed
Air Filter Restriction Pressure
Altitude
High Exhaust Temperature
Oil Filter Differential Pressure
Fuel Filter Differential Pressure
Crankcase Pressure
Aftercooler Water Temperature