CUTTER-TUBE 1U7648 - Caterpillar

Illustration 7 g06017138
Rear view
(C) Existing 148-8372 Elbow As
(E) 141 degree angle
(9) 7J-9108 O-Ring Seal
(16) 157-2348 Elbow
Install elbow (16) on connector (10) at the angle shown using O-ring seal (9).
Mount gear pump group (17) on engine using previously removed mounting bolts.
Connect the previously removed lines to flange (D) and elbow (C).
Illustration 8 g06017230
(F) Fabricated hose assembly - 465-0358 Hose As
(16) 157-2348 Elbow
Connect the straight end of previously fabricated hose assembly (F) to elbow (16).
Illustration 9 g06017240
(F) Fabricated hose assembly - 465-0358 Hose As
Route hose assembly (F) under the main control valve to the hydraulic oil tank as shown in Illustration 9.For machines equipped with a 358-9332 or 358-9322 Hydraulic Generator Arrangement (15 kW), skip to Step 12.
Illustration 10 g06017264
Front view of hydraulic oil tank
(G) Existing elbow - 148-8352 Elbow As
Illustration 11 g06017278
Front view of hydraulic oil tank
(F) Fabricated hose assembly - 465-0358 Hose As
(3) 5K-9090 O-Ring Seal
(7) 6V-8945 O-Ring Reducer
(8) 6V-9840 Swivel Tee
(9) 7J-9108 O-Ring Seal
(11) 9X-6579 Orifice Nut
Replace existing elbow (G) with swivel tee (8) using two O-ring seals (3).
Add reducer (7) using orifice nut (11).
Using O-ring seal (9), connect fabricated hose assembly (F) to reducer (7).Note: This action completes the installation for machines not equipped with a 358-9332 or 358-9322 Hydraulic Generator Arrangement (15 kW).
Illustration 12 g06017338
(H) Existing tee
Remove existing tee assembly (H).
Illustration 13 g06017785
(F) Fabricated hose assembly - 465-0358 Hose As
(J) Existing tee assembly - 148-8433 Tee As
(1) 2M-9780 O-Ring Seal
(3) 5K-9090 O-Ring Seal
(5) 6V-8398 O-Ring Seal
(6) 6V-8936 Reducer
(7) 6V-8945 O-Ring Reducer
(8) 6V-9840 Swivel Tee
(9) 7J-9108 O-Ring Seal
(11) 9X-6579 Orifice Nut
(12) 115-8634 O-Ring Tee
Replace existing tee assembly (H) with swivel tee (8) using two O-ring seals (3).
Add reducer (7) using orifice nut (11).
Using O-ring seal (9), connect fabricated hose assembly (F) to reducer (7).
Disconnect existing tee assembly (J) and insert reducer (6) with tee (12) using one O-ring seal (1) and two O-ring seals (5).
Illustration 14 g06017856
(K) Existing hose assembly - 138-7947 Hose As
(6) 6V-8936 Reducer
Connect hose (K) to reducer (6).