CUTTER A 5P1658 - Caterpillar

Located on the outboard side of the air tank1. Disconnect air pressure sensor wiring harness (2) at the electrical connection. Remove bolt (1), the washer, and the clips that hold pressure sensor assembly (3) to the frame. Remove air pressure sensor (4) from the pipe connector. The following step is for the installation of sensor (air pressure). Check all components for wear or damage and replace if necessary. Apply 1U-6396 O-ring Compound to all O-ring seals prior to installation, if applicable.2. Install air pressure sensor (4) to the pipe connector. Put pressure sensor assembly in position to the frame. Install bolt (1), the washer, and the clips that hold pressure sensor assembly (3) to the frame. Connect air pressure sensor wiring harness (2) at the electrical connection.