CUTTING EDGE 4T8074 - Caterpillar

Introduction
The problem that is identified below has a known permanent solution that is currently being developed. Until the permanent solution is available, use the solution that is identified below.Problem
The J1939 Data link on EMCP 3.2 and EMCP 3.3 (CAN1) may cease to communicate with other modules on the data link. This issue happens when the modbus data link is being used in a scenario where there is high modbus SCADA traffic.Excessive modbus data link traffic with EMCP 3, 2.2 prod software English flash file and EMCP 3.3 or EMCP 3.2 hardware may cause the J1939 (CAN 1) data link to stop working.Part number for English flash file software is 322-2285 Generator Set Software Gp . Other language flash file part numbers range from 322-2196 to 322-2305.Solution
In order to determine if generator package is covered by this publication you must have the following conditions satisfied.The EMCP 3.2 part number should be 300-7646 Generator Set Control Gp or EMCP 3.3 part number should be 300-7647 Generator Set Control Gp .Any one of the below mentioned generator set software part number must be used.
Table 1
Generator set software part numbers    
322-2196     322-2214     322-2290    
322-2197     322-2215     322-2291    
322-2198     322-2216     322-2292    
322-2199     322-2217     322-2293    
322-2200     322-2218     322-2294    
322-2201     322-2219     322-2295    
322-2202     322-2220     322-2296    
322-2203     322-2221     322-2297    
322-2204     322-2280     322-2298    
322-2205     322-2281     322-2299    
322-2206     322-2282     322-2300    
322-2207     322-2283     322-2301    
322-2208     322-2284     322-2302    
322-2209     322-2285     322-2303    
322-2210     322-2286     322-2304    
322-2211     322-2287     322-2305    
322-2212     322-2288        
322-2213     322-2289        The customer should be using the modbus SCADA data link on the EMCP 3.If the unit is affected, The interim corrective action will be to change EMCP software.Repairing dealers are required to contact Dealer Solution Network (DSN) for approval before performing the procedure in this publication. The repairing dealer should have generator package serial number, engine hours, EMCP 3 part number and EMCP 3 software part number. Once approval is given to perform the change, the Dealer Solution Network (DSN) will provide the proper EMCP software.A new flash file is being developed as a permanent corrective action and will be available at a future date.