CUTTING EDGE 4T9560 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     -     Guide Stud
(5/8 - 18 NF) - 6 in     1    
B     6V-4876     Lubricant     1    Start By:
Raise Hood
Turn the battery disconnect to the OFF position.
Remove belt. Refer to Operation and Maintenance Manual, "Belts - Inspect/Adjust/Replace"
Illustration 1 g02496118
Remove bolts (1) and pulley (2) from vibration damper (3) .
Illustration 2 g02497517
Remove top bolt (5) from vibration damper (4). Install Tooling (A) in place of the bolt. Remove remaining bolts (4) and vibration damper (4) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
B     5P-1733     Seal Locator     1    
C     5P-1737     Bolt     3    
D     9S-8858     Nut (Seal Installer)     1    
E     6V-6142     Seal Installer     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Do not use any type of lubricant during the installation of the crankshaft front seal and the wear sleeve.
Before installation of the crankshaft front seal and the wear sleeve, inspect the crankshaft for scratches. Also, inspect the crankshaft for any distortion on the surface that may lead to an out of round condition. Use a polishing cloth in order to remove any imperfections on the crankshaft.
Clean the outside diameter of the crankshaft.
Illustration 3 g01255654
Use Tooling (C) in order to attach Tooling (B) to the crankshaft.Note: Install the crankshaft front seal with the arrow that shows the direction of crankshaft rotation toward the front of the engine.
Position wear sleeve (2) and crankshaft front seal (1) as a unit on Tooling (B). Install Tooling (E) on Tooling (B). Lubricate the face of the washer on Tooling (D). Install Tooling (D) on Tooling (B) .
Tighten Tooling (D) until Tooling (E) contacts Tooling (B) .
Remove Tooling (D) and Tooling (E) from Tooling (B) .
Remove Tooling (C) and Tooling (B) from the crankshaft.