CUTTING EDGE 7F1457 - Caterpillar

Table 1
Required Parts List    
Item     Qty     Part Number     Description    
4     1     4P-8134     Clip    
5     1     7K-1181     Cable Strap    The below rework procedure for 247-5631 Sensor Harness As is adaptable to the machines (S/N: EED1-1193; EXD1-116; DLS1-1185; JRP1-2440; JXP1-162).The updated 247-5631 Sensor Harness As is effective in production for the machines (S/N: EED1194-UP; EXD117-UP; DLS1186-UP; JRP2441-UP; JXP163-UP).Use the following rework procedure to update the 247-5631 Sensor Harness As :
Illustration 1 g02235373
(2) 247-5631 Sensor Harness As
Remove the cable straps (1) and discard the parts.
Illustration 2 g02235414
Illustration 3 g02235454
Remove the bolt (3) and install a clip (4) by using the same bolt (3). Tighten the bolt.
Bundle the harness slack atop the clip (4) with the cable strap (5) as shown in Illustration 3.Note: Harness should not rub the underside of the frame. Harness should not be stressed at the back of the connector or at the bends in the bundle.