CYL AS-HYD 10R0054 - Caterpillar

*Do not use as a replacement for 9N6600 Seal in BrakeSaver A- Seal Installation Location on Engine.B- Seal Group Part Number.1 Use The Correct Tools For Seal Group Installation
Two new tools are needed to install the new seals. The new tools are the 6V6142 Installer Tool and the 6V6143 Installer. For seal installation, use the procedure given for 3400 Series Engines in Special Instruction Form SMHS7100. During the installation procedure, use the 6V6142 Installer instead of the 6V2086 Installer for installation of a front seal, and use the 6V6143 Installer instead of the 6V2087 Installer for installation of a rear seal. All other tools needed for the seal installation are the same as those given in Special Instruction Form SMHS7100.2 Separation Of The Seal From The Sleeve Is Not Permissible
The material in the large lip of the seal can be damaged easily. Fingers, fingernails, wires or the edge of the sleeve can put a scratch on the surface of the seal lip. It is possible that a scratch or a rub (which can not be seen) from a finger, can damage the seal enough that it can not be used. In these seal groups, the sleeve is installed in the seal, by the seal group supplier, for two very good reasons, as follows: A. To give better protection to the special material on the seal lip.B. To make for easier installation. The seal and the sleeve are installed, both at the same time.3 Once There Is Separation Of A Seal And Sleeve, They Must Not Be Used Again
Once there is separation of a sleeve and seal, one from the other, they can not be used again. When you try to put the seal on the sleeve, or the sleeve in the seal, the sleeve will always damage the seal, and neither part can be used again. Always install a new seal group if there is separation of these two parts.4 Used Seal Groups - Do Not Use Again
During the disassembly procedure for engine reconditioning, the seal is separated from the wear sleeve. This means that the sleeve must not be used again. The lip of the seal will be damaged if it is installed over the wear sleeve. Destroy the original wear sleeve and seal. Install the correct seal group at time of engine assembly.5 Install Only Those Seal Groups That Are Still Assembled By The Seal Group Supplier
See items 2, 3 and 4. If during seal group installation, there is separation of the seal from the wear sleeve, remove and destroy both parts. Install a new seal group.6 Seal Groups Are To Be Installed Dry (No Lubrication)
Do not use any type of lubrication during installation of the seal group. The seal group will install quite easily without lubrication, if the correct tools and procedure are used for the installation. If any type of lubrication is used in the installation of the seal group, the result can be an early failure of the seal.