CYL GP-HYD-YM 4237867 - Caterpillar

Illustration 1 g00110307
When the ripper tip is worn close to the shank, replace the ripper tip. If the tip is too blunt, the tip will not penetrate properly.
Raise the ripper. Place blocking under the ripper. Lower the ripper onto the blocking. The ripper should be high enough so that the ripper tip can be removed. Do not place the ripper too high.
If the ripper tip is worn, drive out the pin. Remove the tip and the shank pin retainer.
Clean the shank pin retainer and the pin.
Install the new tip and the retainer.
Install the pin from the opposite side of the retainer.
Raise the ripper and remove the blocking.
Lower the ripper to the ground.