CYLINDER AS 0814157 - Caterpillar

Illustration 1 g00545894
AWD SWITCH GRAPHICExpected Result:The resistance is less than 1000 ohms.Results:
No - Proceed to test step 3.
Yes - Proceed to test step 4.Test Step 3.
Replace the all wheel drive lamp. Use a new Caterpillar part for replacement.PartsReference: Refer toTroubleshooting, "8X-7721 WIRING GP-SHIFT CONSOLE PIN 1AL408-UP. PART OF 8W-6315 CHASSIS AR".System OperationReference: Refer toTroubleshooting, "AWD Mode Switch".Schematic...
Illustration 2 g00545894
AWD SWITCH GRAPHICExpected Result:The all wheel drive lamp has been replaced.Results:
Repair Complete - Stop.Test Step 4.
Use a 6V-7070 Digital Multimeter in order to measure the resistance at the harness for the all wheel drive lamp. Measure the resistance between wire 202-BK and the frame ground. The resistance should be less than 2 ohms.Schematic...
Illustration 3 g00545894
AWD SWITCH GRAPHICExpected Result:The resistance is less than 2 ohms.Results:
Yes - Proceed to test step 5.
No - Proceed to test step 6.Test Step 5.
Connect the harness connector to the all wheel drive lamp. Disconnect the harness from the all wheel drive ECM.
Use a 6V-7070 Digital Multimeter in order to measure the resistance at the harness for the all wheel drive ECM. Check for continuity between contact 32 (wire 486-PK) and contact 2 (wire 202-BK). Measure the resistance between contact 32 (wire 486-PK) and contact 2 (wire 202-BK). The resistance should be less than 1000 ohms.Schematic...
Illustration 4 g00550731
ECMExpected Result:The resistance is less than 1000 ohms.Results:
Yes - Proceed to test step 7.
No - Proceed to test step 6.Test Step 6.
Repair the faulty harness or replace the faulty harness. Use new Caterpillar parts for replacement.Expected Result:The harness has been repaired or the harness has been replaced.Results:
Repair Complete - Stop.Test Step 7.
Clean the contacts on the harness for the all wheel drive ECM. Connect the harness to the all wheel drive ECM.
Turn the key start switch to the ON position. Put the all wheel drive ECM in the service mode. Clear all the inactive faults from the all wheel drive ECM.
Check the all wheel drive ECM for the 396-05 fault code.How...Reference: Refer toTroubleshooting, "Using The ECM Display For Troubleshooting".Expected Result:The 396-05 fault code is present.Results:
Yes - Proceed to test step 8.
No - The fault does not exist at this time. The initial fault was probably caused by a poor electrical connection at one of the harness connectors. Resume normal machine operation. Stop.Test Step 8. Perform the following test: All Wheel Drive Electronic Control - TestResults:
OK - Stop.
REPAIRED, OK - Stop.