CYLINDER KIT 0R3518 - Caterpillar

Measuring and Adjusting Actuation Calibration Reading
Allow the turbocharger to cool.
Illustration 346 g03494537
Install Indicator GP (D). The indicator can be mounted to a loose turbocharger as shown above or mounted to the engine. It may be necessary to use 6V-6042 Indicator Point to mount the Indicator (D).
Illustration 347 g03494580
Adjust the indicator (D) so that it is in-line with the actuator arm. This will ensure an accurate reading.
Illustration 348 g03432078
Remove hose (1) from the actuator (2).
Illustration 349 g03495862
Install hose (B) onto kit (A) by using clamp (C). Connect the opposite side of hose (B) onto actuator (2) by using clamp (C).
Close the air pressure regulator on kit (A).
Connect shop air to kit (A). Do not exceed the maximum inlet pressure for the regulator supplied in kit (A).
Slowly open the regulator on kit (A). Observe the actuator (2) extending the shaft. Close the regulator. Observe the actuator (2) retracting the shaft. Repeat this cycle three times. This will ensure an accurate reading.
Illustration 350 g03496057
Illustration 351 g03432125
Turn on the knob on the air pressure regulator kit (A) and slowly increase the air pressure while you observe the dial indicator (D). Increase the air pressure until the travel of the actuator rod (2) is 1 mm (0.039 inch). Observe the pressure gauge and record the pressure reading. The actuator (2) should always travel 1 mm (0.039 inch) when the actuator (2) is set to the specified pressure in Table 28
Close the regulator.
Adjust actuator (2) as needed.
To increase the calibration setting, increase the preload on the actuator spring by screwing the rod end further toward the canister. Each half turn is an increase of 3.4 kPa (0.5 psi).
To decrease the calibration setting, decrease the preload on the actuator spring by unscrewing the rod end further away from the canister. Each half turn is a decrease of 3.4 kPa (0.5 psi).
Repeat step 8 through 11 until the actuator (2) is set to the spec in Table 28.