CYLINDER HEAD GP 1077320 - Caterpillar

the following procedure to adjust the base timing of the engine:Note: Data from a fuel analysis is required for this procedure.Note: The "First Desired Timing" parameter is only configurable for the Non-EPA certified arrangement.The "First Desired Timing" is disabled for the EPA certified arrangement.
Connect the Caterpillar Electronic Technician (ET) to the engine.
Verify that the value of the "First Desired Timing" parameter is correct according to the recommended timing in the Engine Performance, "Fuel Usage Guide". Enter the correct values if the existing values are incorrect.Refer to Systems Operation, "Electronic Control System Parameters" for additional information on the "Desired Timing" parameters.
Verify that the input for the selection of the base timing is appropriate for the type of gas that is used.
When terminal J1-20 is open circuit (is not connected to ground), the Electronic Control Module (ECM) will use the value of the "First Desired Timing" parameter as the base timing.If the input is not correct, troubleshoot the circuit for the input. Refer to the electrical schematic for the engine.
Start the engine. Run the engine at rated speed and load.
Use Cat ET to view the "Actual Engine Ignition Timing" status parameter. This parameter is in "General System Parameters". Verify that the actual timing is approximately equal to the desired timing.Note: The actual timing may vary according to the engine load, speed, and the detonation level.