CYLINDER GP-HYDRAULIC 1170832 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Open the engine hood.
Drain water separator (5). Attach a suitable hose to the drain valve that is located on the bottom of water separator (5) .
Illustration 1 g00626765
Loosen hose clamp (2) and remove fuel line (1) from the filter base.
Disconnect hose assembly (4) from the filter base.
Remove two bolts (3) and remove water separator (5) from the machine.Installation Procedure
Illustration 2 g00626765
Position water separator (5) onto the engine and install two bolts (3) .
Connect hose assembly (4) to the filter base.
Install fuel line (1) to the filter base and tighten hose clamp (2) .
Prime the fuel system. Refer to Operation and Maintenance Manual, KEBU7502 for the correct procedure.
Close the engine hood.