CYLINDER AS 1175760 - Caterpillar

Truck Engines:
C-10 (S/N: 8YS1-UP)
C-12 (S/N: 9NS1-UP)
Service Manual Module, RENR1318-01, "Disassembly and Assembly", Page 71, "C-10 & C-12 Truck Engines"In the "Cylinder Head Assembly" section, the procedure for tightening the cylinder head bolts has been changed. Refer to the following procedure in order to tighten the cylinder head bolts.
Lubricate the following components with 6V-4876 Lubricant : the bolt threads, the underside of the bolt heads and the washers. Install the cylinder head bolts and the washers. Follow Step 16 for the correct tightening procedure.
Illustration 1 g00517501
Note: Engines that are equipped with a compression brake will have three head bolt studs. Install the head bolt studs in positions (2), (8), and (10). Tighten the head bolt studs in sequence with the cylinder head bolts.
Tighten the cylinder head bolts according to the following procedure:
Tighten bolt (1) through bolt (26) in a numerical sequence to a torque of 160 15 N m (120 11 lb ft).
Tighten bolt (1) through bolt (26) again in a numerical sequence to a torque of 160 15 N m (120 11 lb ft).
Place an index mark on bolt (1) through bolt (26). Rotate bolt (1) through bolt (26) in a numerical sequence for an additional 90 degrees (1/4 turn).
Loosen bolt (1) through bolt (26) until the washers are loose under the bolt heads.
Tighten bolt (1) through bolt (26) in a numerical sequence to a torque of 160 15 N m (120 11 lb ft).
Tighten bolt (1) through bolt (26) again in a numerical sequence to a torque of 160 15 N m (120 11 lb ft).
Place an index mark on bolt (1) through bolt (26). Rotate bolt (1) through bolt (26) in a numerical sequence for an additional 90 degrees (1/4 turn).
Tighten bolt (27) through bolt (33) in a numerical sequence to a torque of 28 7 N m (20 5 lb ft).