1183966 CYLINDER & LINES GP-BUCKET Caterpillar parts
318B, 320B, 320B FM LL, 320B U
Rating:
Alternative (cross code) number:
CA1183966
118-3966
1183966
CA1183966
118-3966
1183966
EXCAVATOR,
Compatible equipment models: 1183966:
Information:
Diesel engine exhaust contains products of combustion which may cause personal injury.Always start and operate the engine in a well ventilated area, and, if in an enclosed area, vent the exhaust to the outside.
Do not crank the engine for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking again.Turbocharger (if equipped) damage can result, if the engine rpm is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient.
Starting The Tractor Engine
Illustration 1 g01283030
Turn the battery disconnect switch for the tractor to the ON position and turn the battery disconnect switch for the scraper to the ON position. Failure to have both battery disconnect switches in the ON position will produce faults.
Move transmission control (6) to the NEUTRAL position.
Unlock the steering column. Move the steering column to the desired position and lock the steering column.
Engage parking brake control switch (5) .
Move joystick control (4) to the HOLD position. Note: Before any implements will operate, all implement controls must be in the NEUTRAL position or the OFF position for two seconds after the engine is started.
Move all implement controls to the NEUTRAL position or the OFF position. For specific information on the operation of the implement controls that are affected, refer to the following topics (if equipped):
Operation and Maintenance Manual, "Bowl Control (Joystick)"
Operation and Maintenance Manual, "Ejector Control (Joystick)"
Operation and Maintenance Manual, "Apron Control (Joystick)"
Operation and Maintenance Manual, "Bail Control (Joystick)"
Operation and Maintenance Manual, "Auger Control (Joystick)"
Operation and Maintenance Manual, "Elevator Control (Joystick)"Note: If the temperature of the coolant is below 0 °C (32 °F), the coolant temperature switch will cause ether to be automatically injected into the engine.
Turn engine start switch (1) in order to start the engine. Release the engine start switch when the engine starts. Starting The Scraper Engine
Starting The Engine From The Operator Compartment
Follow Step 1 through Step 6 in "Starting The Tractor Engine". Note: If the temperature of the coolant is below 0 °C (32 °F), the coolant temperature switch will cause ether to be automatically injected into the engine.Note: If the temperature of the coolant is above 0 °C (32 °F), the coolant temperature switch will cause the air inlet heater to be activated when the engine start switch is turned to the ON position.
Turn engine start switch (1) to the ON position. Note: Do not attempt to start the scraper engine before air inlet heater lamp (3) goes out.
Press the top of engine start switch (2) in order to start the scraper engine. After the engine starts, release the switch. Starting The Engine From The Scraper Control
Follow Step 1 through Step 2 in "Starting The Engine From The Operator Compartment".
Illustration 2 g01283044Note: Do not attempt to start the scraper engine before air inlet heater lamp (8) goes out.
While the key is in the ON position, push engine start switch (7) upward. After the engine starts, release the switch.
Caterpillar SIS machinery equipment:
Caterpillar SIS
320B & 320B L Excavators 4XW00001-UP (MACHINE) POWERED BY 3066 Engine »
118-3966
CYLINDER & LINES GP-BUCKET
318B L & 318B LN Excavators 3LR00001-UP (MACHINE) POWERED BY 3046 Engine »
118-3966
CYLINDER & LINES GP-BUCKET
320B & 320B L TRACK-TYPE EXCAVATORS 5BR00001-UP (MACHINE) POWERED BY 3066 ENGINE »
118-3966
CYLINDER & LINES GP-BUCKET
320B N TRACK-TYPE EXCAVATOR 4NR00001-UP (MACHINE) POWERED BY 3066 ENGINE »
118-3966
CYLINDER & LINES GP-BUCKET
320B FOREST MACHINE 6LS00001-UP (MACHINE) POWERED BY 3066 ENGINE »
118-3966
CYLINDER & LINES GP-BUCKET
320B U 320B LU TRACK-TYPE EXCAVATORS BAN00001-UP (MACHINE) POWERED BY 3066 ENGINE »
118-3966
CYLINDER & LINES GP-BUCKET
Caterpillar parts catalog:
Parts cylinder Caterpillar catalog:
1183955
CYLINDER & SEAL GP-STICK
320B, 320B FM LL, 320B U
320B, 320B FM LL, 320B U
2128566
CYLINDER BLOCK GP
318C, 319C, 320B, 320C, 320C FM, 320C L, 320D, 320D LRR, 321C
318C, 319C, 320B, 320C, 320C FM, 320C L, 320D, 320D LRR, 321C
1346987
CYLINDER GP-BUCKET
311, 312, 320B, 320C, 322B, 322B L, 322C, 322C FM, 325, 325B L, 325C
311, 312, 320B, 320C, 322B, 322B L, 322C, 322C FM, 325, 325B L, 325C
1838171
CYLINDER HEAD AS
320B, 320C, 320C FM
320B, 320C, 320C FM
1838174
CYLINDER HEAD AS
320B, 320C, 320C FM
320B, 320C, 320C FM
1156429
CYLINDER
318B, 320B, OEMS
318B, 320B, OEMS
1225077
CYLINDER
315B FM L, 317B LN, 318B, 320 L, 320N, OEMS
315B FM L, 317B LN, 318B, 320 L, 320N, OEMS
1028112
CYLINDER
1090, 1190, 1190T, 1390, 2290, 2390, 2391, 320 L, 320B, 320B FM LL, 322B L, 322C, 324D FM, 325, 325 L, 325B, 325B L, 511, 521, 522, OEMS, TK711, TK721, TK722, TK741
1090, 1190, 1190T, 1390, 2290, 2390, 2391, 320 L, 320B, 320B FM LL, 322B L, 322C, 324D FM, 325, 325 L, 325B, 325B L, 511, 521, 522, OEMS, TK711, TK721, TK722, TK741
0874783
CYLINDER
320 L, 320B, 321B, 322B L, 322B LN, 325, 325 L, 325 LN, 325B, 325B L, 539, M325B
320 L, 320B, 321B, 322B L, 322B LN, 325, 325 L, 325 LN, 325B, 325B L, 539, M325B
1297771
CYLINDER AS
320B
320B
1232125
CYLINDER AS
320B, 320B FM LL, 320C FM, 325B, 375
320B, 320B FM LL, 320C FM, 325B, 375
1261945
CYLINDER AS
320B
320B
3994713
CYLINDER BLOCK GP
CB34B, CB34B XW, CC34B
CB34B, CB34B XW, CC34B
3879067
CYLINDER BLOCK GP
308E, 308E CR, 308E SR
308E, 308E CR, 308E SR
3951267
CYLINDER GP-BLADE
301.7D, 301.7D CR, 302.2D
301.7D, 301.7D CR, 302.2D
1459312
CYLINDER BLOCK AS
3606, C280-6
3606, C280-6
3287084
CYLINDER HEAD GP
C175-16, C175-20
C175-16, C175-20
1281142
CYLINDER HEAD GP
G3512, G3516, G3516B, PMG3516
G3512, G3516, G3516B, PMG3516
3264411
CYLINDER & SEAL GP-BUCKET
315D L, 318D L
315D L, 318D L
7E4664
CYLINDER BLOCK GP
3512, G3512
3512, G3512
1297831
CYLINDER & SEAL GP-STICK
345B, 345B II, 345B L, 365B
345B, 345B II, 345B L, 365B
1W5281
CYLINDER HEAD GP
16G, 245, 3406, 621B, 623B, 824C, 825C, 826C, 980C, 983B
16G, 245, 3406, 621B, 623B, 824C, 825C, 826C, 980C, 983B
1595455
CYLINDER & LINES GP-STICK
550, 550B, 560B, 570, 570B, 580, 580B
550, 550B, 560B, 570, 570B, 580, 580B