1188288 CYLINDER GP-STEERING Caterpillar parts
950G, 962G, IT62G
Rating:
Alternative (cross code) number:
CA1188288
118-8288
1188288
CA1188288
118-8288
1188288
Weight: 87 pounds 39 kg.
INTEGRATED TOOLCARRIER, WHEEL LOADER,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
Compatible equipment models: 1188288:
Information:
Illustration 1 g02476252
Connections of the Heated Mirrors Relay
This diagnostic code is associated with the Heated Mirrors Relay. The heated mirrors relay is powered by an "ON/OFF" driver circuit. The FMI 03 diagnostic code is activated when the Relay Driver Module detects an above normal voltage of the relay circuit. The Relay Driver Module detects voltage on the relay circuit when the driver is turned off. This diagnostic code is activated on the Machine ECM via CAN Datalink.The following conditions could cause this diagnostic code to be activated:
The relay has failed.
The relay circuit is shorted to a power source.
The Relay Driver Module has failed. A failure of the Relay Driver Module is unlikely.Note: Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, that all connections are secure and that all connections are in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE RELAY FOR A SHORT
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness connector from the relay. Disconnect the machine harness connector J1 from the Relay Driver Module.
At the machine harness connectors for the Relay Driver Module, measure the resistance between contact J1-2 (wire C543-GY(Grey)) and each of the other circuits that are used in the J1 connector for the Relay Driver Module. Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The resistance measurements do not indicate a short to another circuit in the machine harness. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. Repair: The short is between wire C543-GY(Grey) and the circuit that measured a low resistance measurement.For information on testing for short circuits and finding short circuits, refer to Testing and Adjusting, "Wiring Harness (Short Circuit) - Test". Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE OPERATION OF THE RELAY DRIVER MODULEThe disconnect switch and the key start switch remain in the OFF position. The machine harness connectors for the relay and the Relay Driver Module remain disconnected.
At the machine harness connector J1 for the Relay Driver Module, use a 151-6320 Removal Tool to remove the relay wire C543-GY(Grey) and the socket at contact J1-2 from the harness connector.
Reconnect the machine harness J1 connector to the Relay Driver Module.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the active CID
Caterpillar SIS machinery equipment:
Caterpillar SIS
950G Wheel Loader 4BS00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
962G Wheel Loader 5AS00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
950G Wheel Loader 2JS00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
950G Wheel Loader 2JS00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
962G Wheel Loader 3BS00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
962G Wheel Loader 3BS00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
IT62G Integrated Toolcarrier 6PS00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
950G Wheel Loader 8JW00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
950G Wheel Loader 8JW00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
962G Wheel Loader 6EW00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
962G Wheel Loader 6EW00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
950G Wheel Loader 3JW00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
962G Wheel Loader 4PW00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
950G Wheel Loader 5FW00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
950G Wheel Loader 5FW00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
962G Wheel Loader 7BW00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
962G Wheel Loader 7BW00001-UP (MACHINE) POWERED BY 3126 Engine »
118-8288
CYLINDER GP-STEERING
950G WHEEL LOADER 6NS00001-00251 (MACHINE) POWERED BY 3126 ENGINE »
118-8288
STEERING CYLINDER GROUP
Caterpillar parts catalog:
Parts cylinder Caterpillar catalog:
1605130
CYLINDER HEAD GP
120H, 120H ES, 120H NA, 135H, 135H NA, 3116, 3126, 320B, 322B L, 322B LN, 322C, 322C FM, 325B L, 35, 45, 525B, 533, 535B, 539, 543, 55, 550, 561M, 570, 574, 580, 613C II, 928G, 938F, 938G, 950F, 950F ...
120H, 120H ES, 120H NA, 135H, 135H NA, 3116, 3126, 320B, 322B L, 322B LN, 322C, 322C FM, 325B L, 35, 45, 525B, 533, 535B, 539, 543, 55, 550, 561M, 570, 574, 580, 613C II, 928G, 938F, 938G, 950F, 950F ...
1250024
CYLINDER GP-LIFT
950G, 950G II, 962G, 962G II, IT62G, IT62G II
950G, 950G II, 962G, 962G II, IT62G, IT62G II
1605136
CYLINDER HEAD GP
30/30, 3116, 3126, 45, 938F, 960F, 962G, DEUCE
30/30, 3116, 3126, 45, 938F, 960F, 962G, DEUCE
1188296
CYLINDER GP-LIFT
950G, 950G II, 962G, 962G II, IT62G, IT62G II
950G, 950G II, 962G, 962G II, IT62G, IT62G II
1630324
CYLINDER GP
924G, 950G, 950G II, 950H, 962G, 962G II, 962H, IT62G, IT62G II, IT62H
924G, 950G, 950G II, 950H, 962G, 962G II, 962H, IT62G, IT62G II, IT62H
1407373
CYLINDER HEAD AS
120H, 120H ES, 120H NA, 135H, 135H NA, 30/30, 3116, 3126, 320B, 322B L, 322B LN, 322C, 325B L, 525B, 533, 535B, 539, 543, 550, 561M, 570, 574, 580, 613C II, 928G, 938F, 938G, 950F, 950F II, 950G, 953C...
120H, 120H ES, 120H NA, 135H, 135H NA, 30/30, 3116, 3126, 320B, 322B L, 322B LN, 322C, 325B L, 525B, 533, 535B, 539, 543, 550, 561M, 570, 574, 580, 613C II, 928G, 938F, 938G, 950F, 950F II, 950G, 953C...
3058141
CYLINDER BLOCK GP
120H, 120K, 120K 2, 12K, 12M, 135H, 140G, 140K, 140K 2, 140M, 160K, 30/30, 3126, 3126B, 3126E, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 325C, 325C FM, 325D, 325D FM, 325D FM LL, 325D...
120H, 120K, 120K 2, 12K, 12M, 135H, 140G, 140K, 140K 2, 140M, 160K, 30/30, 3126, 3126B, 3126E, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 325C, 325C FM, 325D, 325D FM, 325D FM LL, 325D...
1189001
CYLINDER GP-TILT
950G, 950G II, 962G, 962G II
950G, 950G II, 962G, 962G II
1630325
CYLINDER AS
120K, 120K 2, 120M, 12K, 12M, 12M 3, 12M 3 AWD, 140K, 140K 2, 140M, 140M 3, 140M 3 AWD, 160K, 160M, 160M 3, 160M 3 AWD, 924G, 950G, 950G II, 950H, 950K, 962G, 962G II, 962H, 962K, IT62G, IT62G II, IT6...
120K, 120K 2, 120M, 12K, 12M, 12M 3, 12M 3 AWD, 140K, 140K 2, 140M, 140M 3, 140M 3 AWD, 160K, 160M, 160M 3, 160M 3 AWD, 924G, 950G, 950G II, 950H, 950K, 962G, 962G II, 962H, 962K, IT62G, IT62G II, IT6...
1250028
CYLINDER AS
950G, 950G II, 962G, 962G II, IT62G, IT62G II
950G, 950G II, 962G, 962G II, IT62G, IT62G II
1720936
CYLINDER
143H, 163H NA, 950F II, IT62G
143H, 163H NA, 950F II, IT62G
1518208
CYLINDER AS
950G, 950G II, 962G
950G, 950G II, 962G
1647174
CYLINDER GP-EXTENDABLE STICK
416C, 416D, 420D, 424D, 428C, 428D, 432D, 438C, 438D, 442D
416C, 416D, 420D, 424D, 428C, 428D, 432D, 438C, 438D, 442D
3610718
CYLINDER GP-BUCKET
374D L
374D L
3585972
CYLINDER GP-BOOM
330D L, 330D LN, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E L, 336E LH, 336E LN, 336F L, 340D2 L, 568 FM LL
330D L, 330D LN, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E L, 336E LH, 336E LN, 336F L, 340D2 L, 568 FM LL
1099009
CYLINDER BLOCK GP
3408E, 631D, 631E, 631G, 633E II, 637E, 637G, 657E, 69D, 769C, 769D, 771D, 834B, 836, 988B, 988F II, AD40, AD45, AE40, AE40 II, D8L, D9N, D9R, PM-565, PM-565B
3408E, 631D, 631E, 631G, 633E II, 637E, 637G, 657E, 69D, 769C, 769D, 771D, 834B, 836, 988B, 988F II, AD40, AD45, AE40, AE40 II, D8L, D9N, D9R, PM-565, PM-565B
7C8207
CYLINDER HEAD GP
206, CB-424, CS-323, PR-75
206, CB-424, CS-323, PR-75
3084731
CYLINDER HEAD GP
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E, 444E, AP-650B, AP-800D, CB-534D, CB-564D, CP-433E, CP-533E, CS-533E, PS-150C, PS-360C
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E, 444E, AP-650B, AP-800D, CB-534D, CB-564D, CP-433E, CP-533E, CS-533E, PS-150C, PS-360C
1183971
CYLINDER & SEAL GP-BUCKET
318B, 320B, 322B L, 325B L, 330B L, 345B L
318B, 320B, 322B L, 325B L, 330B L, 345B L