CYLINDER BLOCK AS 1228600 - Caterpillar

Remove pins (43) by cutting the pins from wiring (40).
Remove two screws (41). Separate switch cover (42) from handle assembly (20).
Illustration 16 g00806609
Remove switch assemblies (44), cover (42), and wiring (40) by pulling from handle assembly (20).
Illustration 17 g00806613
Remove nuts (45), switch assemblies with seals (44), and wiring (40) from cover (42).
Illustration 18 g00806616
Remove cap (46) from switch assemblies (44).
Illustration 19 g00806617
Use Tool (B) to remove snap ring (48) from the end of shaft (47). The shaft is located on the inside of handle (20).
Illustration 20 g00806621
Remove handle (20) from cover (49). If necessary, replace the gasket on cover (49).
Illustration 21 g00806622
Illustration 22 g00806624
Remove seal (50) from handle (20).
Illustration 23 g00806625
Remove shaft assembly (47) from cover assembly (49).
Illustration 24 g00806628
If necessary, remove washer (51) from shaft assembly (47).
Illustration 25 g00806629
Illustration 26 g00806630
Use Tool (C) to remove bearing (52) from cover assembly (49).
Repeat step 29 on the opposite end of cover assembly (49).
Illustration 27 g00806632
Illustration 28 g00806634
Use two large screwdrivers to pry bearing (2) from control group housing (3).
Illustration 29 g00806636
Remove screw (53) and cam (54) from lock assembly (55).
Illustration 30 g00806638
Remove nut (56), the washer, and lock assembly (55) from control group housing (3).