CYLINDER HEAD GP 1238650 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
The keel cooled engine header tank can be installed in various places. Ref to the Original Equipment Manufacture (OEM) for the correct location.
The engine can start automatically. Ensure that the power supply is isolated before any service or repairs is performed.
Drain the coolant from the cooling system to a level below the coolant level switch, into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedure.
Illustration 1 g03716574
Typical example
Illustration 2 g03716575
Disconnect harness assembly (3) from coolant level switch (2).
Use a deep socket to remove coolant level switch (2) from expansion tank (1).
Remove O-ring seal (4) (not shown) from coolant level switch (2). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the coolant level switch is free from wear or damage.
Illustration 3 g03716575
Illustration 4 g03716574
Typical example
Install a new O-ring seal (4) to coolant level switch (2).
Use a deep socket to install coolant level switch (2) to expansion tank (1). Tighten the coolant level switch to a torque of 25 N m (221 lb in).
Connect harness assembly (3) from coolant level switch (2).
Refill the cooling system to. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct procedure.
Connect all electrical supplies system to the engine and the control systems.