CYLINDER HEAD GP 1273513 - Caterpillar

Illustration 1 g03114188
Connections of the Fuel Level SensorThis diagnostic code is associated with the Fuel Level Sensor. The FMI 04 means that the Implement ECM has determined that the voltage of the sensor signal circuit is below normal.The possible causes of this diagnostic code are listed below:
The signal circuit for the sensor is shorted to ground.
The sensor has failed.
The Implement ECM has failed. This condition is unlikely. Note: Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, that all connections are secure and that all connections are in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Test Step 1. CHECK THE SENSOR
Turn the disconnect switch and the key start switch to the ON position.
Ensure that the diagnostic code is active.
Observe the status of the diagnostic code. Disconnect the sensor from the machine harness.Expected Result:The CID 0096 FMI 04 diagnostic code changes to a CID 0096 FMI 03 diagnostic code when the sensor is disconnected from the machine harness.Results:
YES - The CID 0096 FMI 04 diagnostic code changes to a CID 0096 FMI 03 diagnostic code when the sensor is disconnected. The sensor has failed.Repair: The sensor is causing the problem. Replace the temperature sensor.STOP
NO - Disconnecting the sensor from the machine harness did not change the status for the active diagnostic code. The CID 0096 FMI 04 diagnostic code is still active. The sensor is not causing the problem. Proceed to Test Step 2.Test Step 2. CHECK THE SENSOR CIRCUIT FOR A SHORTThe sensor remains disconnected from the machine harness.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the