CYLINDER GP-STABILIZER 1311847 - Caterpillar

1. Remove two bolts and install two M16 x 2 x 185 mm guide bolts (2) as shown.2. Remove remaining six bolts (1). 3. Position flywheel (3) on guide bolts (2) as shown. Fasten a lifting strap to flywheel (3) and remove it. The weight of the flywheel is 51 kg (112 lb).4. If the flywheel ring gear needs to be replaced, position the flywheel on a wooden block. Use a hammer and punch to remove the ring gear. Install the flywheel in the reverse order of removal.5. If the flywheel ring gear needs to be installed, heat the ring gear to a maximum temperature of 300°C (572°F). Position the ring gear so the part number is facing toward the crankshaft. After the ring gear is cool, use a soft drift to be sure the ring gear is seated against the shoulder on the flywheel.6. Put 3M Scotch Grip Fastener Adhesive 2353 or Loctite Dri-Loc 203 on eight bolts (1) before installing.7. Check the flywheel runout. Refer to the "Specifications" module, Form No. SENR5560 for the correct procedure to check flywheel runout.